Catalogs >
Rakon >
RSX-5

RSX-5
5Pages

Catalog excerpts

rakon --[--[■Communication Crystals Low profile SMD AT-cut quartz crystal in a ceramic package with a 5 mm x 3.2 mm footprint. -[[[[[-duct description Miniature low profile AT-cut quartz crystal. True SMD style, ceramic package with metal lid, seam sealed. The product is supplied on tape and reel. Applications • Handset • GPS • PDA • Automotive • Consumer • PND • Communications • Military Features • Excellent shock and vibration performance • Low aging • Very good short term stability 1.0 SPECIFICATION REFERENCES Line Parameter Description 1.4 Rakon part number FREQUENCY CHARACTERISTICS Parameter Frequency Calibration tolerance Reflow shift Frequency stability over temperature Temperature range Frequency perturbations Static temperature hysteresis Long term stability g Sensitivity Test Condition Frequency at 25°C ±2°C and specified load capacitance Two consecutive reflow as per attached profile after 4 hours recovery at 25°C Referenced to frequency reading at 25°C and the specified load capacitance Operating temperature Peak-to-peak deviation from the frequency versus temperature curve fit. Minimum of 1 frequency reading every 3°C over operating temperature range Frequency change after reciprocal temperature ramped over the operating range. Frequency measured before and after at 25°C Frequency drift over 1 year at 25°C Gamma vector of all three axes from 30Hz to 1500Hz Value Unit

Open the catalog to page 1

ELECTRICAL Parameter Load capacitance (CL) Shunt capacitance (C0) Pullability Drive level Equivalent series resistance (ESR). Fundamental Insulation resistance (IR) Test Condition Frequency is calibrated to a load at room temperature. Operating specification Operating specification Unit pF pF ppm/pF |jW n Mn Line Parameter Description Half sine-wave acceleration of 100g peak amplitude for 11ms duration, 3 cycles in each plane After 48 hours at 85°C 85% relative humidity non-condensing Exposed at -40°C for 30 minutes then to 85°C for 30 minutes constantly for a period of 5 days. 10g RMS...

Open the catalog to page 2

Open the catalog to page 3

Open the catalog to page 4

NOTE: The product has been tested to withstand the Reflow Profile shown. The Reflow Profile used to solder Rakon RSX/RGX crystals are determined by the solder paste Manufacturer's specification. It is recommended that the Reflow Profile used does not exceed the one shown above. TITLE: RSX/RGX CRYSTAL Pb-FREE REFLOW RELATED DRAWINGS: SCALE: NTS rakon © 2009 Rakon Limited

Open the catalog to page 5

RSX-5 5Pages

Catalog excerpts

All Rakon catalogs and technical brochures

RSX-5
5Pages