rakon SMD Low Acceleration Sensitivity TCXO / TCVCXO. A series of surface mountable Temperature Compensated Voltage Controlled Crystal Oscillators (TCVCXOs) for applications where phase noise performance under vibration is critical. sjjSduct description The RFPT700 TCVCXO uses Rakon's proprietary ASIC 'Pluto™', a single chip oscillator with analogue compensation circuit, and a patented crystal resonator design, resulting in high stability over a wide temperature range paired with typically 0.2ppb/g acceleration sensitivity, Applications • Communications • Avionics • Guidance • Military SPECIFICATION REFERENCES Parameter Description Rakon part number RoHS compliant Package size Description RFPT700 Yes (non-RoHS version available upon request) 14.7 x 9.2 x 4.35 mm (max) 2.0 FREQUENCY CHARACTERISTICS Line Parameter Test Condition over temperature 2.5 Temperature range stability, HCMOS output 2.8 Supply voltage stability, clipped sinewave output 2.9 Load sensitivity, HCMOS output 2.10 Load sensitivity, Clipped Sinewave Output 2.11 Long term stability At 25°C±2°C, at time of shipment, reference to nominal frequency After 1 hour recovery at 25°C Reference to (Fmax + Fmin)/2 (note 1) Operating temperature range over which temperature stability is measured (note 2) Temperature ramp 1°C/minute ±5% variation, reference to frequency at nominal supply voltage, typically less than... ±5% variation, reference to frequency at nominal supply voltage, typical less than... ±5pF variation, reference to frequency at 15pF load, typically less than... ±10% variation, reference to frequency at 10k//10pF, typically less than... first year, s 26MHz first year, > 26MHz 10 years, s 26MHz 10 years, > 26MHz Gamma Vector over operating temperature range (typically 0.2ppb/g) Unit MHz ppm ppm ppm °C ppb/°C ppm ppm ppm ppm ppm ppm ppm ppm ppb/g

Line Parameter Test Condition Value Unit Standard supply voltages: 3.3 and 5.0V (±5%), other values 2.5 to 5.7 V available upon request. typically: 1+frequency(MHz)*supply(V)*{load(pF)+15}*10-3mA mA 4.0 OSCILLATOR OUTPUT HCMOS (optional) - note 3 Test Condition Line Parameter 4.2 Output voltage level high 4.4 Rise and fall times 4.5 Rise and fall times Measured with Vcc = 3.3V Measured with Vcc = 5.0V Measured at 50% level Value Unit Value Unit 5.0 OSCILLATOR OUTPUT CLIPPED SINEWAVE (optional) - note 3 Line Parameter Test Condition 5.2 Output voltage level Peak...

Line Parameter Test Condition SSB phase noise Typical value for a 20MHz Clipped sine wave oscillator at 25°C power density at 1Hz offset SSB phase noise Typical value for a 20MHz Clipped sine wave oscillator at 25°C power density at 10Hz offset SSB phase noise Typical value for a 20MHz Clipped sine wave oscillator at 25°C power density at 100Hz offset SSB phase noise Typical value for a 20MHz Clipped sine wave oscillator at 25°C power density at 1kHz offset SSB phase noise Typical value for a 20MHz Clipped sine wave oscillator at 25°C power density at 10kHz offset SSB phase...

Description Control Voltage (Vc) OR Do not connect (depending on option selected) Not connected GND Output Not connected Supply Voltage (Vs) Description includes rakon Part Number (Exxxx) Frequency (MHz) Pad 1 identifier (indent) Device date / location code DISCLAIMER Parameter Description Disclaimer “Samples supplied according to this specification are supplied from our development or pre- 13.0 Line 13.1 production programme and as such are not qualification approved products. No condition, warranty or representation regarding quality, suitability, performance, life or continuation of supply...

FRONT VIEW SIDE VIEW PIN CONNECTIONS ARE DETAILED IN THE SPECIFICATION RECOMMENDED PAD LAYOUT (Top View) TITLE: RFPT700 MODEL RELATED DRAWINGS:

Sn-Pb EUTECTIC REFLOW SOLDERING PROFILE* NOTE: THE PROFILES WERE USED DURING THE QULIFICATION TESTING OF THE PRODUCT AND THEREFORE REPRESENT WORST CASE CONDITIONS. THEY ARE NOT RECOMMENDED FOR USE BY THE CUSTOMER IN THE ACTUAL ASSEMBLY OF THESE PARTS. TITLE: PLUTO USTCXO REFLOW RELATED DRAWINGS: SCALE: NTS rakon © 2009 Rakon Limited