Low Noise Oscillator series LNO 5000 B3 OCSO @ 5000 MHz Specific request can be addressed to RAKON [email protected] Product Description LNO 5000 B3 is a low noise oscillator generating an output signal at 5000 MHz. It is composed by an OCSO (Oven Controlled SAW Oscillator) at 500 MHz fundamental frequency, followed by a frequency multiplier x10. It can optionally include a PLL to be phase locked on an external 10MHz reference. LNO 5000 B3 is designed for routine environment (test equipment, shelter, ground based military equipment ...). It is available in a 120.7mm x 76.2mm x 23.3mm package. Features Excellent phase noise performance (typical values) :  -121 dBc/Hz @ 1 kHz offset  -146 dBc/Hz @ 10 kHz offset  -157dBc/Hz noise floor Instrumentation (test equipment, simulator) Ground based military equipment as per MIL-PRF-28800F, Class 3 Clock for high speed ADC Rakon reserves the right to modify herein specifications and information when necessary to provide optimum perform

rakon Low Noise Oscillator series Technical Description LNO 5000 B3 is available in two different versions : • Standard version : in this case, it is a VC-OCSO (Voltage Controlled, Oven Controlled SAW Oscillator) that can be used either in free run mode, or controlled by an external DC voltage. • PLL version : in this case, the unit needs an external 10 MHz reference to operate, and the output signal is phase-locked to this reference. Standard version block diagram Power Mfit PLL version block diagram Lock Status . Rakon reserves the right to modify herein specifications and information when...

Low Noise Oscillator series LNO 5000 B3 OCSO @ 5000 MHz Specifications 1.0 Environmental conditions Operating temperature range Storage temperature range As per MIL-PRF-28800F, Class 3, test equipment Random vibration As per MIL-PRF-28800F, Class 3, test equipment Test Condition Electrical interface Test Condition Operating Range Absolute Maximum Supply voltage Load impedance Control input voltage Control input impedance Reference input frequency Reference input level Pin 1, sine wave, 50  source and load Lock status Open drain Test Condition Nominal output frequency Output power Sine wave into...

Low Noise Oscillator series LNO 5000 B3 OCSO @ 5000 MHz 3.9 Steady state power consumption Warm-up power consumption Warm-up time 9 1 ppm with reference to frequency reached after 1 hour of continuous operation Loop bandwidth Steady state power consumption Warm-up power consumption Warm-up time Single side band phase noise (PN) Test Condition PN power density @ 1 kHz offset PN power density @ 10 kHz offset PN power density @ 1 MHz offset Harmonic distortion Other than harmonic distortion Full offset range jitter Broadband jitter Static conditions, at 25°C (guaranteed values on full temperature...

Low Noise Oscillator series LNO 5000 B3 OCSO @ 5000 MHz 5.0 Mechanical features Outline in mm, nominal values (general tolerances : 0.15mm). Standard version : DC control voltage input PLL version : 10 MHz reference input Mechanical and electrical ground (-) Standard version : not used PLL version : Lock status Lock OFF -> ‘0’ Lock ON -> ‘HiZ’, pull-up limited to 3.6V Mechanical and electrical ground (-) Rakon reserves the right to modify herein specifications and information when necessary to provide optimum performan