adio 433.92MHz 00K Superhet Receiver Module It’s an OOK Superhet Data Receiver Module. Very Low Cost version. The main features are the following : 2) Supply Voltage from 2.0Volt to 5.5Volt 3) Fast Startup Time 3ms The difference between the two versions is that the RCRX2 version does not have the pin 1. Compliant with harmonics standards: Technical Characteristics Mechanical Dimension : Applications : Pads - Wireless security systems - Home and building automation - Automatic Measure Reading - Wireless Sensor Network - Industrial Monitoring Radiocontrolli s.r.l refuses any responsibility for irregular uses of the devices and for Pag- 1 / 2 any possible lack or inaccuracy of the data and reserves the right to change in whole www.raai°contr°Nl.com or in part these information without notice.

ontrolli Wireless Modules Typical application The receiver module must be powered from a regulated voltage. In proximity of the receiver module it is necessary to insert a ceramic decoupling capacitor (100nF). The ground plane must be completely encircle the entire receiver in particular the area of the Antenna connection (we recommend a minimum of 40-50mm radius). The 50ohm connection should be as short as possible. For a pcb with 1.6mm thickness, the track “50ohm connection” must be 2.5mm, this track should be separated from the GND for 2mm. On the opposite side of 50ohm connection should be...