RC-CC1101-SPI-SMT-915 Sub 1GHz Multichannels Radio Transceiver It is a low cost sub 1GHz multichannels transceiver designed for low-consumption wireless applications. The hardware is based on Texas Instruments CC1101 component. Programmable from external microcontroller via SPI interface. Operative Frequency Band : 915MHz Technical Characteristics For more information and details, please refer to the CC1101 Texas Instruments datasheet. It uses an industrial high precision 26MHz crystal. - Bidirectional multichannel Link - Wireless security systems - Home and building automation - Automatic Measure Reading - Industrial Control and Monitoring - Wireless Sensor Network Radiocontrolli s.r.l refuses any responsibility for irregular uses of the devices and for any possible lack or inaccuracy of the data and reserves the right to change in whole or in part these information without notice.

Recommended Hardware design 1) Hardware All unused pins should be left floating; do not ground. All GND pins must be well grounded. Traces should not be routed underneath the module. 2) Power Supply The transceiver module must be powered from a regulated voltage. It is recommended to keep the power supply line for VCC as short and low impedence as possible. Near the power pins it is recommended to insert a ceramic the decoupling capacitor (100nF). 3) Ground Plane It is recommended to have a copper ground plane under the module. The ground plane should be unbroken. 4) Module Placement The antenna...

Recommended Reflow Profile for Lead Free Solder Radiocontrolli s.r.l refuses any responsibility for irregular uses of the devices and for any possible lack or inaccuracy of the data and reserves the right to change in whole or in part these information without notice.

Radiocontrolli s.r.l refuses any responsibility for irregular uses of the devices and for any possible lack or inaccuracy of the data and reserves the right to change in whole or in part these information without notice.

FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user' s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed...

RC-CC1101-SPI-SMT-915Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v012.2 List of applicable FCC rules CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter simultaneously transmitting host manufacturer have to This module is stand-alone modular. If the end product will involve the Multiple condition or different operational conditions for a stand-alone modular transmitter in a host, consult with module manufacturer for the installation method in end system. This module is Limited modular without shielding,...