adio Sub 1GHz Multichannels Radio Transceiver It is a low cost sub 1GHz multichannels transceiver designed for low-consumption wireless applications. The hardware is based on Texas Instruments CC1101 component. Programmable from external microcontroller via SPI interface. Operative Frequency Band : ISM 433MHz Applications : - Wireless security systems - Home and building automation - Automatic Measure Reading - Industrial Control and Monitoring - Wireless Sensor Network Feature : - Bidirectional multichannel Link Radiocontrolli s.r.l refuses any responsibility for irregular uses of the devices and for any possible lack or inaccuracy of the data and reserves the right to change in whole or in part these information without notice. Technical Characteristics For more information and details, please refer to the CC1101 Texas Instruments datasheet.

adio 1.2 Mechanicals Dimension (mm)

ontrolli Wireless Modules Recommended Hardware design 1) Hardware All unused pins should be left floating; do not ground. All GND pins must be well grounded. Traces should not be routed underneath the module. 2) Power Supply The transceiver module must be powered from a regulated voltage. It is recommended to keep the power supply line for VCC as short and low impedence as possible. Near the power pins it is recommended to insert a ceramic the decoupling capacitor (100nF). 3) Ground Plane It is recommended to have a copper ground plane under the module. The ground plane should be unbroken. 4)...

ontrolli Wireless Modules FCC Statement This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Country Code selection feature to be disabled for products marketed to the US/Canada. This device is intended only for OEM integrators under the following conditions: 1.The antenna must be installed such that 20 cm is maintained between the antenna and users,and 2.The transmitter module may not be co-located with any other transmitter orantenna, 3.For all products market in US, OEM has to limit the operation channels in CH1 to CH78 for 433M band by...

adio FCC Statement2.5 Trace antennadesigns Not applicable Not applicable This equipment complies with FCC radiation exposure limits setforth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This radio transmitter FCC ID:2ANH5-RC-CC1101-434 has been approved by Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are...