*mydirectindustry

COB-940

Product catalog summary

Overview
The COB-940 is a fiber-coupled LED light source designed for high power applications ranging from UV to NIR. It is compact, user-friendly, and silent, making it suitable for fluorescence, spectroscopy, and general fiber illumination.

Specifications

Electrical Characteristics: Operates with an AC/DC adapter (100-240V, 50-60Hz). Input voltage is 10-18V with a maximum current of 1A. The connector type is DC female 2.1mm for power and SMA female for input signal.
Optical Characteristics: The output connector is SMA 905/FC with a peak wavelength of 940 nm and a spectral range FWHM of 40 nm. Typical optical power output is 29.0 mW.
Other Characteristics: Operating temperature is 0-50 ºC with humidity below 80% HR. Equipment surface temperature is 40 ºC with a stabilization time of 25 minutes. Dimensions are 10.5 x 11.5 x 8 cm, and it weighs 500 g.

Operation Modes
The device can operate in continuous (ON) or pulsed modes. The MODE switch allows selection between ON, OFF, and PULSED. Intensity in ON mode is adjustable between 20% and 100%. In PULSED mode, intensity is controlled via a PWM signal (0-5 V) with recommended frequencies up to 500 Hz for maximum resolution.

Safety Notes

Do not remove or modify safety devices.
Dangerous currents are present; no user serviceable parts inside.
Only qualified personnel should service the unit.
Inspect the unit before first use and do not use if damaged.
Ensure proper ventilation during operation.
Avoid direct eye exposure to optical radiation.

Catalog excerpts

COB-940 Fiber coupled LED Light Source The COB series comprises high power LED light sources with peak wavelengths that range from UV to NIR. They are co nceived as user friendly, compact and silent tools, being ideal for fluorescence, spectroscopy and general fiber illumination applications. These light sources have been designed to obtain a high coupli ng efficiency to optical fiber through a selectable SMA/FC connector. In addition, they can be operated either in continuous (CW) or pulsed modes. (2) Measured with an optical fiber (core diameter 600pm) and a Si photodiode (OPHIR™) www.pyroistech.com [email protected]

Open the catalog to page 1

Operation Modes Connect a proper power source (included with the light source) prior to operation. The light source includes two controls on the front. The MODE switch on the right sets the operation mode between ON (left), OFF (centre) and PULSED (right). The left knob controls the intensity in ON mode (switch on the left position). The intensity can be adjusted between 20% (fully counter-clockwise) and 100% (fully clockwise) of maximum intensity. In PULSED mode (switch on the right position), the intensity can be controlled using a PWM (pulse width modulation) signal through the PWM input connector...

Open the catalog to page 2

COB-940

COB-940

Catalog excerpts

All Pyroistech.sl catalogs and technical brochures