*mydirectindustry

COB-590

Product catalog summary

Overview: The COB-590 is a high-power LED light source designed for applications in fluorescence, spectroscopy, and general fiber illumination. It features a compact and silent design with peak wavelengths ranging from UV to NIR.

Specifications:

Electrical Characteristics: Operates with an AC/DC adapter (100-240V, 50-60Hz). Input voltage is 10-18V with a maximum current of 1A. The pulsed mode requires a 0-5V input signal.
Optical Characteristics: The output connector is SMA 905/FC with a peak wavelength of 590 nm and a spectral range FWHM of 15 nm. Typical optical power output is 2.0 mW.
Other Characteristics: Operating temperature is 0-50 ºC with humidity below 80% HR. The equipment surface temperature is 40 ºC with a stabilization time of 25 minutes. Dimensions are 10.5 x 11.5 x 8 cm, and it weighs 500 g.

Operation Modes: The device can operate in continuous (ON) or pulsed modes. The intensity in ON mode is adjustable between 20% and 100%. In pulsed mode, intensity is controlled via a PWM signal (0-5V) with recommended frequencies up to 500 Hz for maximum resolution.

Safety Notes:

Do not remove or modify safety devices.
Only qualified personnel should service the unit.
Inspect the unit before first use and do not use if damaged.
Ensure proper ventilation during operation.
Avoid direct exposure to optical radiation to prevent eye damage.

Catalog excerpts

COB-590 Fiber coupled LED Light Source The COB series comprises high power LED light sources with peak wavelengths that range from UV to NIR. They are co nceived as user friendly, compact and silent tools, being ideal for fluorescence, spectroscopy and general fiber illumination applications. These light sources have been designed to obtain a high coupli ng efficiency to optical fiber through a selectable SMA/FC connector. In addition, they can be operated either in continuous (CW) or pulsed modes. (2) Measured with an optical fiber (core diameter 600pm) and a Si photodiode (OPHIR™) www.pyroistech.com [email protected]

Open the catalog to page 1

Operation Modes Connect a proper power source (included with the light source) prior to operation. The light source includes two controls on the front. The MODE switch on the right sets the operation mode between ON (left), OFF (centre) and PULSED (right). The left knob controls the intensity in ON mode (switch on the left position). The intensity can be adjusted between 20% (fully counter-clockwise) and 100% (fully clockwise) of maximum intensity. In PULSED mode (switch on the right position), the intensity can be controlled using a PWM (pulse width modulation) signal through the PWM input connector...

Open the catalog to page 2

COB-590

COB-590

Catalog excerpts

All Pyroistech.sl catalogs and technical brochures