Product Details Installation/Disposal Guidelines Mounting Installations High backpressure can cause a delay in dispensing (must be under 5 bar). Mode Button Remove contaminants around the lube point. Select the dispensing period by pressing the MODE button. Once the dispensing period is set, screw the mode cap back on. When the selected dispensing period of the Pulsarlube V has completed, remove the lubricator from the application. Ensure a clear passage using a manual grease gun. Note1 Remove any hardened grease Lubricant Reservoir Cylinder This product is a disposible unit. Dispose of remaining plastic components complying with local regulations for recycling. by purging the lube point with a manual grease gun. Note2 The grease in the equipment and the grease contained in the unit should be the same or compatible. Turn the mode cap counterclockwise and unscrew the cap. Each single press of the button advances to the next setting as follows. Purge Mode Do not cut, puncture, or reuse lubricator. Do not change or recharge the battery. Log the installation date and the scheduled date of lube cycle completion on the label of the Pulsarlube V. Connecting Thread (3/8" M BSPT) If the product is installed at a 45° or 90° angle, please use an angle adapter with a diameter greater than or equal to 1/4". Remove the grease nipple and install appropriate adaptors. Press the MODE button firmly to activate the unit. Purge mode dispenses a large quantity of grease in less than an hour. After the Purge mode is used, reset the unit to the desired dispensing period for further use. Install the Pulsarlube V unit on the lube point. To avoid any potential injury or hazard, do not tamper with the product. For remote installation using an 8mm O.D. tubing, keep the maximum distance at 1m (3ft) or less.

Pulsarlube V Standard Lubricants Product Certifications Certifications Grease Type Multi Purpose High performance multipurpose lubricant Heavy Duty High Speed Excellent extreme pressure lubricant containing solid lubricants Superior high speed (over 3,000 rpm) or high DN lubricant NSF H1 registered food grade lubricant High Temperature High oxidation stability lubricant Multi Purpose with MoS 2 Multipurpose lubricant fortified with extreme pressure additives and MoS 2 Synthetic lubricant for extreme low temp applications (below 15˚C) Electric Motor Bearing High vibration-resistance lubricant...