A USER MANUAL Pulsarlube MS (Machine Synchronized Lubricator) Doc No. 1082-000 REV. 140203 Operating Principles The Pulsarlube MS unit turns “On” or “Off” in synchronization with the equipment on which it is installed. It will dispense the preset amount of grease as long as the machine is operating. If the equipment is not operating, then the Pulsarlube MS unit goes into “stand-by mode” and does not dispense lubrication until the machine operates again. The MS unit is not an externally powered unit. It operates on its own battery. Battery should be replaced simultaneously with grease pouch. The MS unit will turn ON/OFF through a Relay Box in accordance with the related equipment power signal. Main Unit specification Image Product upgrades may occur without prior notice for quality purposes. Item Description Image Voltage Rate Input Note: The MS Relay Box was designed for the Pulsarlube MS unit only. Product warranty will be null &void if any other type of unspecified adapter or converter is used. Operating the Pulsarlube MS ® The MS functioning process Total days

Pulsarlube MS (Machine Synchronized Lubricator) How the MS unit time control programming works (Example: 1 Month Set Mode) 1. If the MS unit is programmed for 1 Month, the # “1” (month) will blink and 30 days will display on the LCD. 2. After 10 days in operation, the “1” will continue to blink and 20 days will display on the LCD. (20 days remaining) 3. MS Unit will go into “stand-by mode” for the amount of time equipment is OFF; in this case = 10days. LCD will not display during stand-by; however CPU will maintain all data at all times via battery pack back up. 4. If equipment is turned ON i.e....