Operation manual Mi
2Pages

Mounting Methods Press To Set Dispensing Period Press for 2 seconds to unlock ( Single Point Installation Direct Mount or Remote Installation using Extension Tubing Direct mount is always preferable. For applications not allowing any direct mounts, remotely mount the unit using appropriate accessories and keep the distance from the lube point as short as possible. Press To Select Grease Capacity (60/125/250ml) Power ON/OFF Hold to power unit on or off For remote installation using a tube, use a 6mm O.D. (1/4") tubing pre-filled with the same or compatible grease as the grease contained in the unit. TEST Mode ON : Press for 2 seconds OFF : Short press of button (Will stop after completion of ongoing cycle) Vibration Detection Mode (Refer to the Installation Guideline Step 7) Multi-Point Installation RESET Reset to default setting when the unit malfunctions and/or after changing the Service Pack Hold the Power button and then press the Mode button Ensure the break-off pressure is below the average operating pressure of 30kgf/cm2 (425psi). The World Leader of Automatic Lubrication ▶ Do not block any ports on divider block and use a divider block corresponding to the number of ports required for multipoint installation. Test Mode (PURGE Mode) Dispensing period setting (Ex. HU-3RS for 3 lube points, HU-5RS for 5 lube points) ▶ For more information, please refer to the Multi-Point Remote Number of days remaining until dispensing period ends Automatic Lock Out mode Number of days operation has been on hold will also be displayed. Grease pouch capacity Maximum runtime has been reached , will also be displayed. Low battery power Excessive backpressure / Operation on hold Empty grease level Installation user. Number of days passed since the end of dispensing period , will also be displayed. Signal lamp blinks periodically when battery power is low, excessive backpressure exists, or if grease level is empty (Reference: Website > Service Menu > Technical Information) Precautions Wiring : Ensure the wire to be keep away from vibration detector. Regular Inspection : Keep the position of the vibration detector vertical. When performing periodic maintenance checks, re-run Vibration Detection Mode to ensure vibration is correctly being detected. Adjust position of sensor box and sensitivity as needed. Replacement Service Pack after the Recommended Use Time : If appears on the LCD after 2 years (250ml : 1 year and 6 months) from the installation date, replace the service pack immediately even if the grease remains in the pouch. (Dispensing failures may occur after long periods of time due to grease hardening and/or drops in battery voltage.) Shelf life and Warranty Product Warranty is limited to original defects in material and workmanship and will not cover any collateral damage due to mishandling, abuse and /or any other inappropriate use of this product. Warranty period is 1 year from the date of purchase. Multi-Point Remote Installation using Progressive Divider Block User Manual 1480 Howard Street, Elk Grove Village, IL 60007, USA TEL:1-847-593-5300 FAX :1-847-593-5303 www.pulsarlube.com / info@pulsarlube.co

Product Details How To Adjust Sensor Level Installation Guidelines 1. Open the yellow cap of sensor box. Remove contaminants around the lube point. Grease Pouch Connect the cable of lubricator and the sensor box cable. Hold and press to start Vibration Detection Mode. Refer to the instructions "How To Adjust Sensor Level" POWER When the equipment is in operation, the clock icon will be displayed. and press to start Vibration Detection Mode. It will last for 60 seconds. POWER When the equipment is not in operation, only the lock icon will be displayed. LCD Display During Improper...