Quantum 3 Sales Brochure
4Pages

QUANTUM 3 Adds the ability to add up to four FlowPulse non-invasive flow monitors. Superior Pumping Station Control The Quantum 3 is a fully-featured pump controller, using Pulsar’s unique non-contacting, ultrasonic technology including DATEM digital echo discrimination to provide sophisticated level management. Quantum 3 can be programmed to provide an alarm based on the time remaining before the station or well spills over, vital for utilities who face the risk of prosecution if a station pollutes the local environment. The Quantum 3 includes all the same unique features seen in the Quantum 2 controller but adds the ability to interface with up to four FlowPulse non-invasive flow monitors, for flow-rate based alarms and control based on measured rather than calculated flow. All intelligent pump controllers by Pulsar Measurement operate in a highly intelligent and predictive manner: with the objective to have a ‘full’ or ‘empty’ well as the tariff charges. The liquid level and the inflow rate is continuously measured and assessed in the well. Both these variables are then related to the time the next tariff charge occurs. If the next tariff charge is for a higher unit cost rate, the well will be allowed to fill to enable pump down immediately before the tariff charge. This then provides maximum storage capacity in the well during the higher tariff period, once in the lower tariff cost period the level is pumped down as normal using the minimum number of pumps. THE RIGHT METER FOR • Pump Control • ‘Time to Spill’ Warning Requirements • Reduction in Power Costs • Pump Monitoring & Control • Pump Station Control The level and inflow condition of the well is continuously monitored to optimize the liquid level and intelligently control the pumps according to the impending tariff charge. By doing this, high tariff charge pumping may be reduced significantly, or avoided entirely, to provide real cost savings on pumping energy charges during higher energy cost periods. Ten set points for tariff variations may be installed, these can be assigned per day, week, or other reoccurring periods to be site-specific.

QUANTUM 3 PUMP CONTROLLER It is important to note that the normal pump on and off points are maintained in storm conditions, thus eliminating the possibility of spills. Actual energy savings achieved will depend on the capacity of the wet well, the frequency of the tariff charges, the size of the pumps, and the relative tariff charges applied. However, cost savings are usually significant. ‘Time to Spill’ & Alarm Programming The Quantum 3 can be programmed to provide an alarm based on the time remaining before the pumping station or well spills over. This is vital for utilities, who face...

Technical Specifications PHYSICAL: MOUNTING OPTION SPECIFIC Mounting Option: Controller Body Dimensions: Weight: Enclosure Material/ Description: Transducer Cable Extensions: Maximum Separation: Max. & Min. Temperature (Electronics): Flammable Atmosphere Approval: Fascia Mount: 200 mm x 112 mm (7.9 in x 4.4 in) front, 165 mm x 105 mm (6.5 in x 4.1 in) cut-out Nominal 1.3 kg (2.9 lb) Stainless steel and polycarbonate, flame resistant to UL94 V0 Twin Screened 1,000 m (3,280 ft) IP64 -20 °C to +55 °C (-4 °F to +131 °F) Safe area: compatible with approved dB transducers allowing installation to...

Quantum 3 Front Drawing Quantum 3 Side Drawing Cut-Out Dimensions Delivering the Measure of Possibility. Pulsar Measurement offers worldwide professional support for all of our products, and our network of global partners all offer full support and training. Our facilities in Malvern, UK and Largo, USA are home to technical support teams who are always available to answer your call or attend your site when required. Our global presence, with direct offices in the UK, USA, Canada, and Malaysia allows us to create close relationships with our customers and provide service, support, training,...