QUANTUM 2 The Quantum 2 provides alarms & ‘time to spill’ warnings of critical areas & resets tripped pumps automatically Superior Pumping Station Control Pulsar Measurement’s Quantum 2 is a fully-featured pump controller, using Pulsar’s non-contacting, ultrasonic technology including DATEM digital echo discrimination to provide solid performance and sophisticated level management. The unit includes 10 relays (digital outputs) and 7 digital inputs and has optional RS485 communications allowing for Modbus RTU, and optional Profibus DP V0 and V1; enabling the status of the unit to be monitored and the controller to be programmed remotely. Digital inputs allow the unit to respond to ‘no-flow’ conditions and the Quantum 2 is able to automatically reset pumps in case of failure, saving unproductive maintenance trips to the site and freeing up staff time for more important work. The Tariff Guard routines, which are common to all intelligent controllers, ensure that energy costs are minimized through periods of maximum electricity tariff, while the Quantum’s unique ‘time to spill alarm’ protects critical pumping stations from uncontrolled overflow. All intelligent pump controllers by Pulsar Measurement operate in a highly intelligent and predictive manner: with the objective to have a ‘full’ or ‘empty’ well as the tariff charges. I N F O @ P U L S A R M E A S U R E M E N T . C O M THE RIGHT METER FOR • Pump Station Monitoring • ‘Time to Spill’ Alarms • Well Monitoring • Pump Efficiency Monitoring • Automated Pump Reset • Predictive Maintenance The liquid level and the inflow rate are continually measured and assessed in the well. Both these variables are then related to the time the next tariff charge occurs. If the next tariff charge is for a higher cost rate, the well will be filled first to enable pump down immediately prior to moving onto the higher tariff charge. This then provides maximum storage capacity in the well during the higher tariff period, once in the lower tariff cost period the level is pumped down as normal using the minimum numb

QUANTUM 2 PUMP CONTROLLER The level and inflow condition of the well is continuously monitored to optimize the liquid level and intelligently control the purpose of the pumps according to the impending tariff charge. By doing this, high tariff charge pumping may be reduced significantly, or avoided entirely, to provide real cost savings on pump energy charges, especially during higher energy cost periods. A typical wet well application where Quantum 2 is used for Pump Control. Ten set points for tariff variations may be installed, these can be assigned per day, week, or other reoccurring periods...

Technical Specifications PHYSICAL: MOUNTING OPTION SPECIFIC Mounting Option: Fascia Mount: Controller Body Dimensions: Enclosure Material/ Description: Stainless steel and polycarbonate, flame resistant to UL94 V0 Maximum Separation: Transducer Cable Extensions: Max. & Min. Temperature (Electronics): Flammable Atmosphere Approval: Twin Screened IP64 -20 °C to +55 °C (-4 °F to +131 °F) Safe area: compatible with approved dB transducers allowing installation to zone 0 EMC approval to BS EN 50081-1: 1992 for emissions and BS EN50082:1995 for immunity and to BS EN610101:1993 for low voltage directive....

Quantum 2 Front Drawing Cut-Out Dimensions Quantum 2 Side Drawing Delivering the Measure of Possibility. Pulsar Measurement offers worldwide professional support for all of our products and our network of distributors all offer full support and training. Our facilities in Malvern, UK and Largo, USA are home to technical support teams who are always available to answer your call or attend your site when required. Our global presence, with direct offices in the UK, USA, Canada and Malaysia allow us to create close relationships with our customers and provide service, support, training and information...