Catalogs >
Pulsafeeder >
Microtrac-Specifications

Microtrac-Specifications
2Pages

Catalog excerpts

MICROtrac Cooling Tower Controller A Unit of IDEX Corporation MICROtrac Toroidal Conductivity Cooling Tower Controller The MICROtrac is a microprocessor based feed and bleed toroidal conductivity controller designed to control conductivity and feed inhibitor in cooling tower systems. Featuring innovative toroidal sensor technology, the MICROtrac provides an economical control platform that is not susceptible to sensor fouling and never requires calibration! Principle of Operation The MICROtrac measures the conductivity of the cooling tower recirculating water via a toroidal conductivity sensor. The controller activates two independent relay outputs based on a bleed and feed mode of operation. When the conductivity measurement goes above the user defined set point, the two relays are activated until the con-ductivity drops below the set point and the fixed differential value, or until the user programmable limit times for feed or bleed are exceeded. Operating Benefits No calibration required! MICROtrac's toroidal sensor technology saves you valuable service time and money by eliminating routine calibrations. The MICROtrac toroidal conduc-tivity sensor is factory calibrated for the life of the probe. Օ Reduced potential for fouling! By design, the MICROtrac toroidal conductivity sensor has no exposed electrodes, which means that there is nothing to wear out or foul. When installed according to the manufacturer's instructions, the need for routine sensor removal and cleaning is virtually eliminated -saving you time and money. Two year warranty on controller and senխsor! You can install the MICROtrac controller with confidence, knowing that it is backed by Pulsafeeder with a two year warranty on the controller and sensor. Large range. The MICROtrac conductivity controlխler has a 0 - 9,999 uS/cm range, making it ideal for other applications as well, such as rinse, industrial process, wastewater, etc. Simple user interface. A large LCD display and simple programming via a three-button interface make the unit extremely easy to set up and pro-gram. With no calibration required and a fixed differential, all that needs to be done is to program a conductivity set point and, if desired, the limit times for the feed and bleed relays. Օ Easy installation. Optional pre-wired receptacles for the relays and an optional pre-wired flowswitch make installation a breeze. technolo innovation excellen

Open the catalog to page 1

MICROtrac Model Slection MICROtrac SELECTION GUIDE MTC PRODUCT DESIGNATOR Position 1, 2 & 3 MTC = MICROtrac Toroidal Conductivity Controller VOLTAGE Position 4 1 = 115 volt XXX RELAY& POWER WIRING Position 5 X = Prewired power cord only P = Prewired power cord and relays SENSOR TEE Position 6 X = Standard (no tee) T = Sensor Tee with 3/4" inlet/outlet connections FLOW SWITCH Position 7 X = Standard (no flow switch) F = Flow Switch with 3' cable SUFFIX CODE Position 8, 9 & 10 XXX = Suffix Code MICROtrac Specifications Controller Specifications Enclosure Nema 4X/ IP65 Dimensions 4.73" x 2.28"...

Open the catalog to page 2

Microtrac-Specifications 2Pages

Catalog excerpts

All Pulsafeeder catalogs and technical brochures

Microtrac-Specifications
2Pages