*mydirectindustry

ZM2.WALL
1 /3Pages

Catalog excerpts

ZM2.WALL WALL MOUNTING BRACKET BRACKET FOR WALL MOUNTING This accessory is used to mount various DIMENSION power supplies and other DIMENSION supplementary modules on a wall or on a panel without using a DINRail. To mount a unit on a wall or panel, the two zinc-plated steel brackets have to be installed on the side of the unit. Check the data sheet to see if the ZM2.WALL brackets are suitable for a specific DIMENSION power supply or supplementary module. INSTALLATION DATA Fig. 1 Unit equipped with brackets The order number consists of two brackets and four mounting screws suitable for one DIMENSION power supply or one DIMENSION supplementary module. Jan. 2014 / Rev. 1.5 DS-ZM2.WALL-EN All parameters are specified at 25°C ambient unless otherwise noted. www.pulspower.com Phone +49 89 9278 0

Open the catalog to page 1

ZM2.WALL WALL MOUNTING BRACKET ASSEMBLY INSTRUCTIONS Fig. 3 Mounting the steel brackets Mounting instructions: Mount the two steel brackets on the sides of the unit by using the self tapping countersunk screws included with the kit. The two brackets are symmetrical so there is no specific left or right side. Two screws are needed for each bracket which requires a Torx-T10 screwdriver. Tightening torque: 0.7-0.8 Nm (6.2-7.1 lb-in) For some narrow units such as the CPS20, the black plastic DIN-rail slide on the back of the unit may overlap with the mounting holes of the steel brackets. In such...

Open the catalog to page 2

WALL MOUNTING BRACKET I PHYSICAL DIMENSIONS AND WEIGHT The information presented in this document is believed to be accurate and reliable and may change without notice. No part of this document may be reproduced or utilized in any form without permission in writing from the publisher. All parameters are specified at 25°C ambient unless otherwise noted.

Open the catalog to page 3