Data sheet SilverLine • Input: AC 230/115V, DC 240...375V • Output: 12-15V/180W • PULS Overload Design™: 20% Power boost up to 215W; high overload current, no switch-off • Robust mechanics and EMC • DC ok LED • Inrush current limiting and Overtemperatur protection Input Input voltage <5A (switch in 115V position) <2.3A (switch in 230V position) AC 100V Unit is internally fused (fuse not accessible). For external fusing of unit and for input line protection, use circuit breaker with B-characteristic 10A or slower action, or alternatively T10A HBC fuse. AC 100V AC 120V AC 230V 0.67 Output voltage DC 12-15V, adjustable by (covered) front panel potentiometer; preset: 12V ±0.5% Adjustment range guaranteed Rated continuous loading with convection cooling • Tamb=0°C - 60°C 12V/15A (180W) resp. 15V/12A • Tamb=0°C - 45°C 12V/18A (215W) resp. 15V/14.4A short-term also at 60°C (< 1 min) Output is protected against short-circuit, open circuit and overload Harmonic current emissions (PFC) see page 2 Transient handling Transient resistance acc. to VDE 0160 / W2 (750V/1.3ms), for all load conditions. Short-circuit current Ambient temperature range Tamb Operation: 0°C...+70°C (>60°C: Derating) Storage: -40°C...+85°C at Tamb = +50°C, cold start Power factor Note: At DC input, always leave the switch in the 230V position Input current In Voltage regulation Ripple / Noise Serial operation Parallel operation Overvolt. protection Power back immunity Front panel indicator Green LED on front panel Construction / Mechanics* Housing dimensions and Weight 120mm x 124mm x 102mm (+ DIN rail) • WxHxD above/below 25mm recommended • Free space for left/right 15mm recommended ventilation 980g • Weight Lifetime expectancy (electrolytics) The unit uses longlife electrolytics, specified for +105°C (cf. ’The SilverLine’, p.2). 0,5...4mm2 / 20...10 AWG • Wire gauge • Recomm. tightening 0,8Nm / 7lb.in torque • Wire stripping length 7mm / 0,275” * For further information see data sheets „The SilverLine“, „SilverLine Family Branches“ and mechanics data sheet Design advantages: • All connection blocks are easy to reach as mounted at the front panel. Ordering information Order number SilverLine switched-mode power supply Adapter for S7-300 rail Wall mounting set

Data sheet Startup delay Rise time Start / Overload Behaviour 5...25ms, depending on load Overload Behaviour • Special PULS Overload – no disconnection, no hiccup if overloaded Design (see diagram – high overload current (up to 2.2 INom), overleaf) Vout is gradually reduced with increasing current. – 18A short-term, at 45°C or forced cooling • 20% power boost even continuous Advantages: • High short-circuit current, giving large ’start-up window’: unit starts reliably even with heavy loads (DC-DC converters, motors). • No ’sticking’ such as can occur with fold-back characteristics • Secondary...