SLSP Standard Series-order codes SUPPORT Location flats Typical Specifications* • * Specifications may vary depending upon installation and loading specifics. • Construction is welded stainless steel 17-4PH, IP67, potted with DoubleSeal protection. • The Standard Series SLSP fits a standard 2130 High Load shackle and can be purchased with optional centering sleeve and anti-rotation cleat. • The SLSP is fitted with an integral M12 4 pole male sensor connector and supplied with the mating female connector. The mating connector accommodates PT cable packs diameter 4~8mm (not supplied). The connector terminals are numbered and should be connected. 1- Excitation +ve, 2- Excitation -ve, 3- Signal -ve, 4-Signal +ve. For 6 wire cables connect the appropriate Sense and Excitation wires to the same connector terminal. The SLSP (Stainless Load Sensing Pin) is a practical measurement device and is rarely fitted to an installation designed for precision weighing. Many of the variables eliminated from accurate weighing installations (side loads, variable contact point, friction, bridging, twisting) cannot be eliminated from a SLSP installation and consequently the performance becomes a compromise. Specifications quoted by PT are those typically achieved under controlled conditions and do not necessarily represent installed conditions.