PREMIUM-H
4Pages

PREMIUM-H RFID card reader PREMIUM-H 125 kHz HID Prox card reader The PREMIUM-H FSK card reader consists of three parts: a potted unit containing the electronics, a front cover, and an optional spacer plate. A fixed 10 way colour-coded cable protrudes from the back of the potted unit. The reader will read the code from an 125 kHz HID Prox transponder and output the code in one of many user selectable formats. The unit also allows for user control of the three LEDs and sounder. A 6-way DIP switch under the front cover is used to select the required output format and LED operational modes. Specifications :     Power requirements: 5.0-13.6V dc. Current consumption is 100 mA typical (80mA at 5V) RF Frequency: 125 kHz Card types supported: HID H10301 (26 bit format), H10304 (37 bit format), … Output formats supported: - Wiegand - Mag Stripe emulation - Clock/Data - RS232 (9600,n,8,1) EIA and TTL levels. Continuous (while tag in the field) or single transmission Typical reading range with supply voltage in range 5.5V-13.6V: - Key fob tag : 30 mm - ISO card : 70 mm Typical reading range with supply voltage at 5.0V: - Key fob tag : 25 mm - ISO card : 60 mm 3 LEDs (GREEN, RED, YELLOW). Buzzer emits a 60ms beep at 4 kHz when a transponder is read. In addition sounder operates while SOUND input is pulled low. Operating temperature range: -20ºC - +60ºC. 10 way cable: 1m long Weight: 90 grams. Dimensions: reader 89 x 45 x 16 mm, optional spacer plate 89 x 45 x 7 mm ProxTech International bvba Zakstraat 104, 9112 Sinaai ( Belgium ) Info @ proxtech.com

PREMIUM-H RFID card reader Physical dimensions and mounting details : Centred cable exit hole All measurements in mm Drawing not to scale If the mounting plate is used the reader cable may be brought out of one of four exit points on the mounting plate: top, bottom, left or right. This enables the cable to be run on the surface of the wall. If no mounting plate is used, a minimum hole size of 6,5 mm must be drilled in the wall at the cable exit position as shown above to allow the cable to exit perpendicular to the reader. The optional mounting plate may also be used when mounting the...

Proxi rech International PREM1UM-H RFID card readerConnections : Colour Note : LED and BUZZER inputs are active low. The input is internally pulled high and may be pulled low by an open collector transistor or driven low by the output of a 5 V CMOS or TTL gate. The 6-way switch is used to select the output format and LED mode. The required setting is selected from the following tables: Output mode table

Proxi rech International PREM1UM-H RFID card reader LED mode table Note : This “continuous transmission” mode can not be guaranteed to work properly on some controllers, depending on the data interfaces. However, the “single transmission” mode will work with all controllers. It is therefore recommended to test this function prior to site activation. The reader has an internal low dropout 5 V regulator and so for maximum performance the input voltage must be smooth DC between 5.5V and 13.6V. The reading distance is unchanged for input voltages between 5.5V and 13.6V. For input voltages below...