Premium - EM
4Pages

PREMIUM-EM RFID card reader PREMIUM-EM 125 kHz RFID card reader The PREMIUMEM card reader is a contactless reader device supporting 125 kHz EM4x02 transponders and compatibles. Due to the fully potted housing, the reader can be installed both indoors and outdoors. An integrated DIP-switch allows an easy selection of the many integrated output formats. Three-colour LED indication and audible tone enhance user feedback. Both beeper and LED’s can be controlled by the host system. Power supply : Power consumption : Transmitting Radio Frequency : Supported transponders : DC +5,0V to 13,6V Typ. 100mA ( 80mA @ 5VDC ) 125KHz 40 bit read only transponders EM4x01 family, HiTag2 Public Mode A, TEMIC e5550 and equivalents  Typ. read range (@ 5.5V-13.6V): Key tag with 20mm coil : 85mm ISO card with 50mm coil : 175mm  Typ. read range (@ 5.0V): Key tag with 20mm coil : 80mm ISO card with 50mm coil : 160mm  Indications : 3 LEDs (Greed/Red/Yellow) + Buzzer Buzzer emits a 60ms beep at 4 kHz when a transponder is read. In addition sounder operates while BUZZER input is pulled low  Data Output format : DIP-switch selectable : - Wiegand (42-bit, 34-bit and 26-bit) - Clock & Data ( 13, 10, 9 or 8 characters ) - RS232 (9600, 4800 or 2400 Bd) (buffered) - RS232 (9600, 4800 or 2400 Bd) (TTL)  Transmission : Continuous (while tag in the field) or single transmission  Connections : 10-wire cable ( 1 m length )  Weight : 90g  Operating Temperature : -20°C ~ +60°C  Mounting : Mullion or wall mount ( Extra mounting plate is supplied with each reader )  Dimensions : 89 x 45 x 16 mm ( dimensions mounting plate : 89 x 45 x 7 mm ) ProxTech International bvba Zakstraat 104, 9112 Sinaai ( Belgium ) Info @ proxtech.com

PREMIUM-EM RFID card reader Physical dimensions and mounting details : Centred cable exit hole All measurements in mm Drawing not to scale If the mounting plate is used the reader cable may be brought out of one of four exit points on the mounting plate: top, bottom, left or right. This enables the cable to be run on the surface of the wall. If no mounting plate is used, a minimum hole size of 6,5 mm must be drilled in the wall at the cable exit position as shown above to allow the cable to exit perpendicular to the reader. The optional mounting plate may also be used when mounting the...

Proxi rech International PREM1UM-EM RFID card readerConnections : Colour Note : LED and BUZZER inputs are active low. The input is internally pulled high and may be pulled low by an open collector transistor or driven low by the output of a 5 V CMOS or TTL gate. The 6-way switch is used to select the output format and LED mode. The required setting is selected from the following tables: Output mode table

Proxi rech International PREM1UM-EM RFID card reader LED mode table NOTE : this “continuous transmission” mode can not be guaranteed to work properly on some controllers, depending on the data interfaces. However, the “single transmission” mode will work with all controllers. It is therefore recommended to test this function prior to site activation. The reader has an internal low dropout 5 V regulator and so for maximum performance the input voltage must be smooth DC between 5.5V and 13.6V. The reading distance is unchanged for input voltages between 5.5V and 13.6V. For input voltages...