PL3000
8Pages

ProxLock 1000 / 3000 Stand-alone access control system User’s manual ProxTech International bvba Zakstraat 104, 9112 Sinaai ( Belgium ) Info @ proxtech.com

ProxLock PL1000 / PL3000 General notes 1. This manual contains all the required information for the use of the products described within. During installation of the power lines, the standard regulations need to be taken in to account. The contents of this manual are verified as closely as possible. Nevertheless, errors can not be excluded. The company bvba ProxTech International declines all responsibility for all problems occurring from this or unauthorized use of the product. 2. In the text hereafter the term “tag” indicates a transponder in either a key fob or ISO card version. General...

Figure 1 : Standard “low security” mounting of the PL1000 ProxTech International bvba Zakstraat 104, 9112 Sinaai ( Belgium ) Info @ proxtech.com

ProxLock PL1000 / PL3000 Figure 2 : Mounting a PL3000 system in a “higher security” environment Outside reader connection Inside reader connection ProxTech International bvba Zakstraat 104, 9112 Sinaai ( Belgium ) Info @ proxtech.com

ProxLock PL1000 / PL3000 Using the PL1000/PL3000 system Access with tag The tag is held in front of the reader and a beep is heard. When the tag is valid, the door opener will be activated for about 5 seconds and the green led turns on. The red led indicates an invalid tag and the door opener will not be driven. Access with PIN code A code up to 6 digits long is entered on the keypad. Each key activation will result in a short beep and a blinking of the yellow led. The code is then confirmed by pressing the “*” key. Should a wrong key be pressed by mistake, the complete code can be erased...

Once entered in programming mode ( master card presented to the reader, yellow led flashing, green led on ), press key 1 to enter the “learning mode” ( yellow and green led flashing ). Enter the memory address ( e.g. for a 500 user version, a number between 000 and 499 ) and confirm by “*”. The system now switches to “read mode” ( red led on, yellow and green led flashing ). Now enter the new PIN code and/or hold the new tag in front of the reader. The system stores the new user in the given memory address and switches back to “programming mode” (yellow led flashing, green led on ). If the...

ProxLock PL1000 / PL3000 The system confirms this reset request with a long beep and all led’s turn on. When the system has been reset ( after approx. 10 seconds ), a short beep is heard and the red and green led turn on. The system now stands in the “master card programming mode”. The first card which is now held in front of the reader will act as the new master card ( short beep ). The system then returns to its default state ( yellow led on ). Quit programming mode Programming mode can be quit by pressing the “#” key. The system then returns to its default state ( yellow led on ). Memory...

ProxLock PL1000 / PL3000 Connections of the PL1000 / PL3000 Connector pin 1+2 Function 9 … 15 Vac or 9 … 15 Vdc ( 1 = Vcc, 2= GND ) RS232 GND Not connected ( optional ANT1 for readers with external antenna ) Not connected ( optional ANT1 for readers with external antenna ) RS232 TXD RS232 RXD Not connected Not connected Not connected Relay contact Relay contact Overview of visual indications Red led Off Off On On Off Off On Flashes Flashes Flashes Flashes Flashes Flashes Flashes Flashes Flashes On Flashes Flashes Off On Flashes ProxTech International bvba Indication Default state Detected...