Don´t let overpressure ruin your performance! Overpressure in air tools leads to earlier wear and tear and break down. The result is expensive Production stops and waste of energy. Overpressure: Every bar/15 psi of excess pressure essentially wastes up to 10% of the energy energy consumption represents approx. 80% of the overall cost in the industry. The majority of air tool manufacturers describe in their operation manual that the tool is designed for a working pressure of 6,3 to 7 bar (90 to 102 psi) = max. torque of the air tool and that warranty will only be approved if the product has been installed, operated and overhauled according to the Operating Instructions. Don´t let it come that far!ensure the optimal pressure for your air tooldon´t let unauthorized personnel tamper with the pressure Select Protect-Air´s smart pre-set In-line Regulators for your air system and air tools. Protect-Air´s In-line preset Regulators prevent „dynamic pressure waste“, which arises when the pressure and the flow at the withdrawal point are unnecessarily higher than those specified by the air tool manufacturers to achieve the desired max. torque of the tool. Head Office TRI-MATIC AG l Bösch 82 l CH-6331 Hünenberg Tel: +41 41 780 22 22 / Fax: +41 780 03 60 [email protected] / www.tri-matic.ch International Marketing & Sales Support Protect-Air l Taunusblick 16 l D-61479 Glashütten Tel: +49 6174 5050 – Fax: +49 617423893 info@prot