100%tapped DETEC: the most affordable “on the shelf” tap detection system; making tap detection easy for both designers and final users. This is the 3rd generation of our patented and compact detection system. It guarentees 100% of the parts are tapped. DETEC V3 is even more compact for an easy installation into any die, the new dedicated seal makes it more oil proof and reduces maintenance. It is compatible with any oil, even the ones containing sulfur or chlorine. DETEC closely monitors the accuracy of your tapping operation, eliminating the need to sort your parts out because of broken taps, a pre-hole too small, or a miss feed. Though completely mechanical, DETEC includes a mechanical sensor that amplifies the motion of the tap to detect even the smallest movement. Then, the signal is transmitted through a flexible cable to a mechanical receptor installed outside of the die. Easily mounted, the sensor and the “prox switch/ detector" are connected to your press control panel to stop the press if a problem occurs. • Detects tap breakage, misfeed, wrong tap set-up • Adjustable Cable length (60-735 mm) and short tap traveL • Limited servicing • Visual Ught (LED) when actuated by tte tap. • Very easy installation and set-up • 100% mechanical for reteMty. • Verycompact to install into any die • Pressure Key with carbide tip.

Set-up nuts Adjustable cable length 60-735 mm New heavy duty sealing boot Pressure Key with carbide tip - 5,5 mm travel capacity Compact housing Mounting screw Compact inductive sensor included 24VCC PNP (NPN option: on demand) Detection stroke 5,5 mm Housing width 15 mm Cable length 60 a 735 mm Available sensor type NPN or PNP and NO or NF In-die solutions