Catalogs >
Promstahl WorldWide >
Loading Ramp With Swing Lip Leveler PAS - Short operating instructions

Loading Ramp With Swing Lip Leveler PAS - Short operating instructions
1Pages

Catalog excerpts

Place this sign near the control unit! Warning Not observing these safety instructions may result in danger to life and health of operator or third parties! • OBSERVE the following safety instructions. • ONLY authorized personnel may operate the dock. • MAKE SURE that the lorry cannot roll away by engaging the brakes and placing a wheel chock or a safety block before starting the loading process. • MAKE SURE that the leveller rests safely on the lorry bed with its whole width during the whole loading process. • NEVER position the dock leveller by hand or by means of other tools. • NEVER operate the dock leveller if it is not in perfect working condition. Faults must immediately be reported to the responsible supervisor. • MAKE SURE that the dock leveller is returned to its cross-traffic position as soon as the loading operation has been completed. • SECURE the dock leveller by means of the inspection support before maintenance. • NEVER exceed the permissible load capacity. • BEFORE any work on the electrical equipment can be started the dock leveller must be de-energized and secured against being switched on again. Short operating instructions (PS/PAS) Attention! To operate the leveller, turn the mains isolator to „1“and leave it in this position. Emergency! Set the mains isolator to „0“; any movement is stopped immediately. Park the lorry in its loading position. - Secure the lorry against undefined movements. Place the dock leveller on the lorry bed. - Press the “LIFT” button on the control unit and keep it pressed until the lip is entirely swung out; release the “LIFT” button. - The leveller automatically comes to rest on the lorry bed. During the loading operation the swing lip must rest safely on the lorry bed with its whole width. - Do not turn the mains isolator to „0“! Return the dock leveller to its cross-traffic position by means of the „AUTO” button. - Briefly press the “AUTO” button after the loading process. - The dock leveller automatically returns to its cross-traffic position.

Open the catalog to page 1