Product Sheet Electrohydraulic PTU dock leveller with divided telescopic lip Version: 1.0.0 Date: 2012-07-16 Page: 1/6 Product Sheet Electrohydraulic PTU dock leveller with a divided telescopic lip All rights to make technical changes reserved

Product Sheet Electrohydraulic PTU dock leveller with divided telescopic lip Version: 1.0.0 Date: 2012-07-16 Page: 2/6 Electrohydraulic PTU dock leveller with divided telescopic lip PROMStahl’s new product, the PTU leveller is a stationary electrohydraulic dock leveller with a divided telescopic lip. It is intended for handling a wide range of vehicles with different structure and loading area dimensions. Depending on the type of docking vehicles (lorry or van), the operator can set adequate mode using a control panel. For vans (with smaller widths of loading space), effective width of the telescopic...

Product Sheet Electrohydraulic PTU dock leveller with divided telescopic lip Version: 1.0.0 Date: 2012-07-16 Page: 3/6 PTU dock leveller operating modes Lorry loading/unloading PTU dock leveller lip extends to its full width. Maximum load capacity of the leveller is 60kN. Van loading/unloading PTU dock leveller lip extends to a reduced effective width of 1200mm. Maximum load capacity of the leveller is 20kN. Load exerted by the leveller on a vehicle does not exceed 2kN. All rights to make technical changes reserved

Product Sheet Electrohydraulic PTU dock leveller with divided telescopic lip Version: 1.0.0 Date: 2012-07-16 Page: 4/6 Place of installation a) With driveway PW – placement width PL – placement length DH – dock height PW – placement width PL – placement height DH – dock height All rights to make technical changes

Product Sheet Electrohydraulic PTU dock leveller with divided telescopic lip Version: 1.0.0 Date: 2012-07-16 Page: 5/6 Types of frames used in PTU dock levellers T type frame Leveller frames to be embedded in concrete are characterised by quick and trouble-free assembly in a single operation W type frame The first to install is the pre-farming structure. The dock leveller can be assembled/installed after construction works are finished (e.g. after floors are laid). The main frame of the leveller is welded to the pre-framing. F type frame This solution enables replacement of worn docks. The leveller...

Product Sheet Electrohydraulic PTU dock leveller with divided telescopic lip Version: 1.0.0 Date: 2012-07-16 Page: 6/6 Preparations for electrical works 1. Electrical control (delivered) 3. Electric cables pipe. Min inner diameter: 50mm. Bends< 45° 4. Power supply connection 3/N/PE AC 50Hz 230/400 V. Protection: DD 10 A. Motor power: 1.5 kW. 7. Door/leveller* lock switch *option All rights to make technical changes reserved