Pneumatic drilling Machine Heavy-duty pneumatic drilling machine with milling/cutting capacity up to 200mm diameter and tapping capacity up to M48 is extremely useful for very special applications on construction sites and industrial installations, where electric appliances are prohibited for safety reasons. Two permanent magnetic bases, pneumatic motor and no. 5 Morse Taper spindle make this machine one of the most powerful portable magnetic drills on the market. Features & benefits: • pneumatic motor and permanent magnetic bases eliminate the need of electric power supply • intended for use in potentially explosive atmospheres • heavy-duty pneumatic motor • strong permanent magnets • ATEX certified drill • protection against accidental motor activation • self-locking devices prevent any incidental deactivation of the permanent magnets • cross slide system for precise hole center locations PRO-200A ATEX conforms to ATEX II 2 G/D c IIC T6/T4 Standard for equipment used in hazardous environments Speed (under load) 20, 80 rpm

A potentially explosive atmosphere exists when a mixture of air gases, vapours, mists, or dusts combine in a way that can ignite under certain operating conditions. The source of ignition could be either electrical or mechanical in origin. Working in explosive atmospheres carries many challenges, including first of all the safety of the workers. Therefore, PRO-200A ATEX complies with ATEX (ATmospheres EXplosibles) directive and is intended for use in the oil, gas and energy industries. PRO-200A ATEX capacity: Milling up to 200mm (7-7/8”) ATTENTION: Cutter guard is not in place for demo purpose...

■ Working on contour surfaces PRO-200A ATEX can be fixed to pipes of min. 950mm Base with permanent magnets can be adapted to a (37.4") diameters workpiece curvature No accidental motor activation possible. Permanent magnets need no power supply from the mains. Operator must simultaneously press the button at the base A self-locking device prevents any possible accidental of the lever and turn the valve lever until it stops, to enable movement of the handle and deactivation of the magnet. motor start-up ATTENTION: Cutter guard is not in place for demo purpose only

PRO-200A ATEX TECHNICAL SPECIFICATION Motor Speeds (under load) Motor Power Tool holder Magnetic clamping force Required ambient temperature Standard set includes: • pneumatic drilling machine • MT5 arbor • 3 feed levers • cooling system 5l • chip guard • drift for MT5 • 4 mm hex wrench • 5 mm hex wrench • 6 mm hex wrench • 8 mm hex wrench • 10 mm hex wrench • 13 mm flat wrench • Operator’s Manual PROMOTECH Sp. z o.o. ul. Elewatorska 23/1, 15-620 BIAŁYSTOK, POLAND tel. (+48 85) 678 34 05, fax (+48 85) 662 78 77 [email protected] www.promotech.eu All information is subject to change without...