Fast & accurate way to determine tapped density for capsule filling. i" Eliminates calculation errors as volume is 1ml. Most manufacturers do not provide tapped density or provide it using 100 or more taps, which does not correlate to capsule filler tapping. Lightweight for use on analytical balances. 1. Place empty Tap DensiMeter on balance and tare the balance. 2. Rotate the top disc, marked “ProFiller”, so its cavity is aligned with the middle disc’s cavity. 3. Fill the cavity with powder you wish to analyze. 4. Gently tap the DensiMeter 10-15 taps or as many taps as you normally tap your capsule filler. 5. Rotate the top disc 90° clockwise to close cavity in middle disk. 6. Turn over Tap DensiMeter and tap out any remaining powder in the top disc. 7. Weigh filled Tap DensiMeter. Your tapped density is the final weight. Example 0.47g means a tapped density of 0.47g/ml. For Balances That Cannot Be Tared: Sample Calculation Density = Mass / Volume Mass = Final weight - Initial weight Volume = 1ml Tapped Density = (Final weight in Step 7 - Initial weight in Step 1) / 1ml Example: Tapped Density = (48.12g-47.65g)/1ml = 0.47g/ml. cleaning instructions on reverse ProTDM SellSheet Tap DensiMeter 1712 DNP

Cleaning, Washing & Drying: Cleaning: Rotate the top disc so it’s cavity is aligned with the middle disc’s cavity and empty out any powder. Washing: To separate the discs, hold the middle disc with the fingers of one hand. Use your remaining hand to pull the top disc away. Repeat to separate the bottom disc. A magnet holds the three discs together. Wash with water and dishwashing liquid. If using an automatic dishwasher, keep parts in the top rack. Drying: Can be dried in a hot air oven up to 60°C for not more than 15 to 20 minutes Made from acrylic. Do not expose to temperatures above 70°C or...