Technical Specifications:
The COMbricks Alternative Cable Repeater (SALT) is designed for PROFIBUS networks, supporting protocols such as DP-V0, DP-V1, DP-V2, FDL, MPI, FMS, PROFIsafe, and PROFIdrive. It does not require a bus address and supports transmission speeds from 9.6 kbps to 12 Mbps, with auto-detection capabilities.

Power and Consumption:
The module is powered through the backplane with a current consumption of approximately 400 mA, with a maximum of 600 mA. If the module is faulty, it will switch off from the backplane.

Oscilloscope and Cable Specifications:
The oscilloscope frequency is 192 MS/s with a resolution of 50 mV and a differential range of -6.436 to 6.436 V. Cable specifications depend on the type used, with a maximum of 31 devices per channel and no limit on cascading depth, except for bus parameter limitations.

Termination and Dipswitch Settings:
Termination ranges from 94 to 940 Ohm (DC) and 57 to 1500 Ohm (AC), with idle voltage ranging from 0 to 5 V. Dipswitch settings allow for network configuration and redundancy settings.

LED Indicators:
The module includes LEDs for status indication, such as readiness, receiving telegrams, internal errors, and signal amplitude issues.

Physical and Environmental Specifications:
The module operates at temperatures between 0 to 60 °C, weighs 120 g, and measures 115 x 100 x 25 mm.

Additional Information:
Software for configuration can be downloaded from the PROCENTEC website. The document includes tables for impedance values and idle voltage settings, providing detailed configurations for different cable types.