Product Data Sheet Heavy Duty Waste Water Pump Overview The Heavy Duty Waste Water Pump offers the ability to pump water levels down to 1mm. It is capable of a flow rate of up to 170 litres per minute with a maximum head of 11 meters. Steel outer casing, cast aluminum pump stand and rubber pump chamber Urethane vortex impeller Removes waste water down to 1 mm depth. Maximum submersion 20 m IP 68 Part Number Weight Discharge Connection Materials 12 kg (dry weight of the pump without cable) 1” (25mm) Shaft Seal Double mechanical seal in oil bath Primary Seal: silicon carbide Secondary Seal: Ceramic on carbon Electric Motor Impeller: Urethane Rubber Motor frame: Aluminum die casting Outer: Steel sheet Shaft: SUS403 (EN-X6Cr13) Dry-type submersible induction motor, Insulation class E, 2 poles, 2850 r.p.m. Capacitor start Voltage: 110V/240V, 50Hz, 1-phase or 2-phase Power input: 0,59kW Power output: 0,48kW Nominal current: 6, 2A (110V) Start current: 14, 2A (110V) Compact Pump Overview The compact semi-submersible pump with polypropylene casing is suitable to pump clear water containing particles with maximum diameter up to 5 mm. Anti-corrosive and rust-proof materials Integrated float switch Very low priming and starting level of the pump (10 to 15 mm) Easy access through sliding cover to float switch for cleaning Motor with thermal overload protection Excellent cooling of the motor that enables the pump to operate even when it is partially submerged Supplied with power cable, plug and non-return valve Lever for quick selection of manual or automatic mode Removes waste water and solids up to 5 mm, down to a depth of 3-6 mm Motor can be partially submerged for short term operation IP68 Part Number Part Number Versar PPS reserves the right to change, modify or discontinue any product listed. Images may be slightly different than actual products. Protection House, Sherbourne Drive, Tilbrook, Milton Keynes, MK7 8HX, Phone: (+44) 01908 272240 L0030