PSCH15 NiMH/NiCD Smart Charger Features • Universal 90-264VAC Input • IEC320 C8 2 pin AC Input Connector • Auto detect output can charge 2 to12 NiMH or NiCD cells in series • Automatic cut off when batteries fully charged • EMC to EN55022’B’, CISPR22 ‘B’ & FCC ‘B’ • Compact Desk Top Plastic Enclosure • Optional DC Output Connectors (2.5 x 5.5mm as standard) www.powersolve.co.uk Electrical Specification INPUT Input Voltage Input Frequency Safety Ground Leakage Current OUTPUT Output Voltage Charging Current LED Charge Status Indicator Over Voltage Protection Short Circuit Protection Reverse Polarity Protection Efficiency ENVIRONMENTAL Operating Temperature Storage Temperature Relative Humidity SAFETY & EMC Safety EMI/EMC MECHANICAL Varies to charge 2.4V to 14.4V DC battery pack 500mA to 1A LED flashes Red then Green twice after power on then switches off in standby LED is Red when charging and turns Green when battery fully charged. LED will flash on and off RED for error status Sense level 18V, OVP at 24V max Short circuit with auto recovery Reverse polarity of battery on output will not damage charger 75% minimum at full load and 115VAC input UL/cUL1310 Class 2, EN60335-2-29:2004, EN60335-1, CE CISPR22 ’B’, FCC Part 15 ’B’, EN55022 ‘B’ UL94V-1 plastic enclosure, dimensions 96 x 44 x 30mm, output cable 1.2 metre Charge Curve This charger can charge between 2 and 12 NiMH or NiCd cells connected in series and will detect and provide the correct output voltage and current to suit. End charge is by -A V (about 5mV for each cell) detection, after -A V. It will turn to trickle-off charge, it’s charger current is fast charging current of 1/20. Warning: This charger should only be used to charge NiMH or NiCD batteries with a capacity between 1000mAH and 4000mAH Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England Tel: 01635 521858 Fax: 01635 523771 Email: [email protected] 08.09.16