AC - DC 80W~90W LED Driver MDC080 Single Output Series Features Built-in 10KV lightning surge protection (EN61000-4-5) 90 ~ 305Vac full range input; Active PFC Output voltage range up to 257Vdc for outdoor lighting Aluminum case IP65/ IP67 waterproof Dual mode over temperature thermal design Output voltage automatic tracing & fixing function Built-in 3 in 1 output current dimming function (Type B) Optional timer dimming function Class 2 power unit / Pass LPS ; Long lasting life time All Series approved to UL/CB/CCC/CE/PSE Outdoor LED luminaries rugged driver solutions 5 years warranty MDC-080-XXXX □ Type A : IP65 grade^Adjust current by variable resistor internal Type B: IP67 grade ■ Output current dimming by 0~10V/10V PWM signal/Resistor

AC - DC 80W~90W LED Driver MDC080 Single Output Series Leakage current < 0.75mA / 277VAC 1. Please refer to "Input Voltage v.s. De-Rating Curve "chart 2. Please refer to " PFC v.s. Load Curve" chart

AC - DC 80W~90W LED Driver MDC080 Single Output Series 1. Please refer to"Temperature v.s. De-Rating Curve "chart Type A % T Case: Maximum temperature of chassis PE ® (GREEN/YELLOW) AC/L (BROWN) AC/N (BLUE) ♦ Dimming Mode (Type B only ) PE ® (GREEN/YELLOW) AC/L (BROWN) AC/N (BLUE) *Do not put "-V (BLACK)" & " - (WHITE)" in connection

AC - DC 80W~90W LED Driver MDC080 Single Output Series ＊Short ~100KΩ adjust output current ( MDC0802450 ) Resistor value Rated Current rate ＊0~10Vdc adjust output current ( MDC0802450 ) 0V Rated Current rate ＊10V PWM adjust output current；Frequency range 100Hz~3KHz ( MDC0802450 ) 0% Rated Current rate Output Current Duty cycle of 10V PWM (frequency range = 100~3KHz) Dimming input ※ Note : 1. The output current drops down to 1.4% when the dimming input is short or 0Vdc. 2 . 0 ~ 1V dimming application please consult sales office V Function Block Power Switching Rectifiers & Filter LED+ Dimming...

AC - DC 80W~90W LED Driver MDC080 Single Output Series  LED Driving Output Mode Powersolve LED driver output characteristics with constant voltage mode (CV) & constant current mode (CC) to direct drive all kinds of LED lighting correctly Connecting LED load start up waveform: No load start up waveform: Vout = Vled ; Iout = Iset (CC) (Iset = Default output current) Vno_load Output voltage curve: Vout = Vled Output voltage curve: Constant voltage Output current curve: Constant current Output current curve: No load 0A Please consult Powersolve to optimize your LED driving configuration!! Output...