PS-12180HD-M5FEATURES Heavy duty (HD) construction with high vibration tolerance Rechargeable Sealed Lead Acid Battery PS HD - Heavy Duty SeriesTERMINALS: (mm) T12: Threaded insert with 5mm stud fastener • Punch-plate design yielding ultra-low impedance • Absorbent Glass Mat (AGM) technology for superior performance • High-rate discharge characteristics matching 'pure lead' products • Valve regulated, maintenace free spill proof construction • Rugged impact resistant ABS case and cover APPROVALS • Approved for transport by air. D.O.T., I.A.T.A., F.A.A. and C.A.B. certified • U.L recognized • ISO9001:2015 - Quality management systems W: 3.03 (77) H: 6.59 (167) HT: 6.59 (167) Tolerances are +/- 0.04 in. (+/- 1mm) and +/- 0.08 in. (+/- 2mm) for height dimensions. All data subject to change without notice. Nominal Voltage Rated Capacity 20-hr. (900mA to 10.80 volts) Approximate Weight Internal Resistance (approx.) Max Discharge Current (5 min.) Max Short-Duration Discharge Current (5 Sec.) Shelf Life (% of nominal capacity at 68°F (20°C) 1 Month 3 Month 6 Month Operating Temperature Range Charge Discharge Case CORPORATE HEADQUARTERS (USA AND INTERNATIONAL EXCLUDING EMEA) Power-Sonic Corporation 7550 Panasonic Way, San Diego, California 92154 T: +1 (619) 661 2020 F: +1 (619) 661 3650 E: [email protected] POWER-SONIC EUROPE LIMITED (EMEA - EUROPE, MIDDLE EAST AND AFRICA) 3 Buckingham Square, Hurricane Way, Wickford, Essex SS11 8YQ T: +44 (0)1268 560686 F: +44 (0)1268 560902 E: [email protected] To ensure safe and efficient operation always refer to the latest edition of our Technical Manual, as published on our website. © 2018. Power-Sonic Corporation. All rights reserved. All trademarks are the property of their respective owners. All data subject to change without notice. E&O.E

SHELF LIFE & STORAGE LIFE CHARACTERISTICS IN CYCLIC USE CHARGERS Cycle Applications: Apply constant voltage charge at 2.35v/c - 2.45v/c (14.1 - 14.7v for 12v Monobloc) at 20°C. Initial charging current should be set at less than 0.25C Amps. Switch to float charge to avoid overcharging. "Float" or "Stand-By" Service: Apply constant voltage charge of 2.25v/c - 2.30v/c (13.5 to 13.8 volts for 12v Monobloc at 20°C. When held at this voltage, the battery will seek its own current level and maintain itself in a fully charged condition. Temperature Compensation: Charging Voltage for both Cyclic and...