RACT25
5Pages

TRIAC Dimmable LED Driver • Triac –dimmable with leading or trailing edge dimmers • Class II with SELV output (no earth required) • Extra-large screw terminals and integrated cable clamps for easy installation • Power factor corrected >0.95 • Dimming range 1..100% • Compatible with a wide range of dimmers AC/DC Converter RACT25 25 Watt 3 TRIAC Dimmable Single Output The RACT25-xxx series are low cost, triac-dimmable, constant current 25W LED drivers available with either 500mA, 700mA or 1.05A full-range outputs. The drivers are Class II (double insulated) meaning no earth connection is required. The phase angle dimming works with leading or trailing edge dimmers. The RACT25 is suitable for indoor locations up to 50°C ambient temperature and is certified for building into furniture for applications such as dimmable shelf lighting, cove lighting or accent lighting. It is CE (LVD + EMC + RoHS) + EAC marked and has IEC61347-1/IEC61347-2-13 CB report certification. Selection Guide Part Number Input Output Output Efficiency Output Voltage Range Voltage Range Current min. @rated load Power [VAC] [VDC] [mA] [%] [W] All LED Drivers may not be used without a load. They must be switched on the primary side only. Noncompliance may damage the LED or reduce its lifetime. Model Numbering IEC/EN61347 certified IEC/EN61347-2-13 certified EN61547 certified EN62493 certifed EN55015 compliant CB report Output Current Output Power Specifications (measured @ Ta= 25°C, 240VAC, rated load unless otherwise specified) BASIC CHARACTERISTICS Parameter Input Voltage Range Input Current Inrush Current No Load Power Consumption Input Frequency Range Power Factor continued on next page

Specifications (measured @ Ta= 25°C, 240VAC, rated load unless otherwise specified) Parameter full load Start-up Time Internal Operating Frequency Output Ripple Current (1) Notes: Note1: Measured at 20MHz BW by using a 12” twisted pair-wie terminated with a 0.1µF and 47µF capacitor parallel across output REGULATIONS Parameter Output Accuracy Load Regulation Line Regulation PROTECTION Parameter Input Fuse fusible resistor Short Circuit Protection (SCP) Latch OFF, auto recovery after fault condition is removed 58VDC max. 45VDC max. 32VDC max. Over Voltage Protection (OVP) Over Load Protection...

Specifications (measured @ Ta= 25°C, 240VAC, rated load unless otherwise specified) Derating Graph (@ Chamber and natural convection 0.1m/s) 100 90 Output Load [%] SAFETY AND CERTIFICATIONS Certificate Type (Safety) Report Number Lamp controlgear Part 1: General and safety requirements (CB Scheme) Lamp controlgear Part 2-13: Particular requirements for d.c. or a.c. supplied electronic controlgear for LED modules (CB Scheme) Lamp controlgear Part 1: General and safety requirements (LVD) Lamp controlgear Part 2-13: Particular requirements for d.c. or a.c. supplied electronic controlgear for...

Specifications (measured @ Ta= 25°C, 240VAC, rated load unless otherwise specified) DIMENSION and PHYSICAL CHARACTERISTICS Parameter Package Dimension (LxWxH) Package Weight wire stripping length: 6-7mm recommended tightening torque: 0.25Nm tc= case temperature measuring point FC fixing centers = Tolerance: xx.x= ±1.0mm xx.xx= ±0.5mm Bottom View Connection via Screw Terminal FC 13.3 without cable cover`s Notes: Note2: The use of sleeve or ferrule terminations is recommended

Specifications (measured @ Ta= 25°C, 240VAC, rated load unless otherwise specified) INSTALLATION and APPLICATION Dimming Type work with leading/trailing edge dimmers PACKAGING INFORMATION Parameter Packaging Dimension (LxWxH) Packaging Quantity Storage Temperature Range Storage Humidity The product information and specifications may be subject to changes even without prior written notice.The product has been designed for various applications; its suitability lies in the responsibility of each customer. The products are not authorized for use in safety-critical applications without RECOM’s...