PRB010 Programming Board for POSIC SMD encoders Product data Features OTP programming of POSIC’s SMD encoder ID4501 Description The Programming Board is intended for OTP-programming of POSIC’s SMD encoder ID4501 prior to soldering. It is compatible to the Interface Board of the Evaluation and Programming Tool EPT002. Fig 1 shows how to connect the Programming Board to the ASSIST Interface Board. Fig 2 shows the opened socket containing an ID4501 encoder. To open the socket, the top side of the black lever must be pushed towards the center of the socket. Align the ID4501 encoder in the socket: - The solder side* (large copper pads) must be facing down. - The sensing side* (small copper pads) must be facing up. - The round copper mark must be at the upper right side in Error! Reference source not found.. In the socket, this corner has a larger recess/indent than the other 3 corners * See ID4501 datasheet Fig 3. Copper mark on package Fig 2 Programming Board, socket with lid open. Ordering information Fig 1 Programming Board (1) connected to ASSIST Interface Board (2), which is connected via USB cable (3) to PC with ASSIST software. Programming board with socket for ID4501 including flat cable for connection to ASSIST Interface Board www.posic.c

Programming Board 1) 8-pin DIN41651 connector to ASSIST Interface Board 3) Encoder Power jumper J7 • Present: encoder powered via ASSIST Interface Board connector • Removed: encoder not powered (can be powered via jumper-pin) © Copyright 2018 POSIC. All rights reserved. No part of this document may be reproduced without the prior written consent of POSIC. Products and companies mentioned in this document may be trademarks or registered trademarks of their respective owners. Information in this document is believed to be accurate and reliable and may be changed without notice. No responsibility...