Compucut® GO is the simple automation solution. It generates cutting programs fully-automatically from the CIP 3/4 files in prepress and then transfers such programs to a D PLUS or N PLUS cutting machine. USB memory stick containing software, sample data and short instructions Network interface card (LEA11 / DBR card) Functions No operator interface Automatic generation and transfer of cutting programs The cutting program is generated according to a definite initial cut sequence Takes additional functions of the machine into account The cutting program can only be sent to one machine No ESPV available (external cutting program administration) No true image possible Commissioning Requires no installation. Program is run right from the USB memory stick Minimal, English-language configuration interface (to select machine) Activation and network configuration on cutting machine / high-speed cutter Prerequisites Windows PC (XP or more recent), network interface card with specific IP-address (no DHCP) and USB port must be available, cutting machine model D PLUS or N PLUS. Graphic representation of sheet available (optional on N PLUS) POLAR-Mohr Maschinenvertriebsgesellschaft GmbH & Co. KG Hattersheimer Straße 16 – 42 \\ 65719 Hofheim \\ Germany [email protected] \\ www.polar-mohr.com Benefits for the customer Process visualization of cutting cycle (optional on N PLUS) Plug and Cut ensure easy start-up Programming time on high-speed cutter reduced to zero Increase in high-speed cutter efficiency In most cases, it pays off after less than six months. Fault rate is radically reduced. Thanks to automatically generated programs including process visualization anyone can operate the high-speed cutter. Edition: 02.2015 \\ Subject to technical alterations. The simple automation solution for D PLUS or N PLUS cutting m