COOLCAP®- COOLING ARBORS For an efficient cooling of solid carbide end mills

COOLCAP® arbor and adapter systems coolc ap ® - milling and media optimised cooling arbors for Solid C arbide End Mills oolcap ®-arbors from POKOLM are the new optimal system for effective cooling of solid carbide end mills. The fact is, with coolcap®-arbors, the volume flow and discharge velocity are perfectly matched to the various mill diameters and the different cooling media. Effective, direct cooling facilitates higher speeds and chips are safely removed from the cutting zone. Additionally, the best possible lubrication action in the cutting zone also guarantees a high surface quality....

coolc ap ® excellent attributes at a gl ance Volume flow and discharge velocity are perfectly matched to the different mill diameters Various coolcap®, structurally designed for the various cooling media of air/MLQ or emulsion Ring-shaped cooling jet for ideal cooling performance and chip flushing The selective supply reduces the compressed air consumption while increasing effectiveness Longer lifetime of the milling tool The low mass of the cap of less than 30 g does not influence the balance quality of the arbor (G 6.3 at 18,000 rpm) When necessary, caps can be simply, quickly and cost-effectively...

COOLCAP® arbor and adapter systems coolcap ® cooling arbors for shrinking, HSK 63, Form A • Hollow taper shank arbors according to DIN 69 893 form A, maximum precision • fine balanced to G 6.3 gmm at 18,000 rpm • with internal coolant supply and bore hole for the coolant supply tube • effective direct cooling for solid carbide end mills because of a ring-shaped cooling jet Designation Application tool Torque wrench Important: the scope of delivery of each COOLCAP cooling arbor includes one cap each. When ordering, please always state whether you want a cap for air/MMS or a cap for emulsion/cooling...

coolcap ® cooling arbors for shrinking, SK 40, DIN 69 871 AD • Steep taper shanks according to DIN 69 871 AD, maximum precision • fine balanced to G 6.3 gmm at 18,000 rpm • with internal coolant supply and bore hole for the coolant supply tube • effective direct cooling for solid carbide end mills because of a ring-shaped cooling jet Designation Application tool Torque wrench Important: the scope of delivery of each COOLCAP cooling arbor includes one cap each. When ordering, please always state whether you want a cap for air/MMS or a cap for emulsion/cooling water. Additional caps can be ordered...

COOLCAP® arbor and adapter systems the coolc ap ® applic ation tool The COOLCAP®- Application tool is for universal use. One single tool is sufficient for process-reliable attaching and removing all COOLCAP®-caps. That means you profit from minimum stock and the bothersome search for the right box wrench or other suitable tools is eliminated. The various wrench widths are clearly marked - each appropriate tightening torque is indicated. That makes operating mistakes virtually impossible with the COOLCAP® system and guarantees long service lives for the caps. The operating principle of the COOLCAP®...

Important operating instructions - please comply! When shrink gripping and shrink releasing tools, always remove the COOLCAP® system caps Never seal COOLCAP® with additional sealants such as PTFE thread seal tape or anything similar Never use an open-end wrench, pipe wrench or adjustable screw-wrench to tighten and loosen the caps. The use of unsuitable tools voids the guaranty Recommended tightening torques: Tool diameter (mm) For long service life and process-reliable tightening and loosening of the caps, compliance with the specified tightening torques is mandatory. NOTE ON BALANCE QUALITY:...

Pokolm Frästechnik GmbH & Co. KG Adam-Opel-Straße 5 33428 Harsewinkel Germany Fon: +49 5247 9361-0 Fax: +49 5247 9361-99 [email protected] www.pokolm.com