SWING CLAMP CYLINDERS SERIES RT RELIABILITY AND DURABILITY

Swing clamp cylinders Series RT The swing clamp cylinder has been developed to meet the need to clamp a workpiece by means of a clamping arm which when released would unclamp rotate 90 degrees in order to allow unrestricted access to the workpiece; the stroke of the swing movement is 21mm. They are supplied in two bore sizes Ø40 and Ø50 in magnetic or non magnetic versions. The swing clamp cylinder is available with standard clamping stroke lengths of 10, 20, 30 and 50mm with both right (R) or left (L) rotation. The following accessories are available: - The clamp bracket can be re-positioned...

Swing clamp cylinders Series RT Swing clamp cylinder M = magnetic piston N = non magnetic piston LINEAR CLEARANCE STROKE 010 = 10 mm 020 = 20 mm 030 = 30 mm 050 = 50 mm R = Right (clockwise rotation) L = Left (counter clockwise rotation) SEALS Pneumatic actuation Linear stroke Fixing with through screws: - M5 screws (for Ø40 bore) - M6 screws (for Ø50 bore) Non-magnetic screws recommended Fixing with non-through screws: - M6 screws (for Ø40 bore) - M8 screws (for Ø50 bore) Clockwise rotation of the clamping arm R Counter clockwise rotation of the clamping arm L The direction of rotation is defined...

Swing clamp cylinders Clamping in linear stroke phase Don't use the cylinder in a horizontal position Don't stress the cylinder radially Don't clamp on an inclined surface Don't clamp moving components Don't clamp during the rotating movement Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Pneumatic actuation Series RT - Application advice

Swing clamp cylinders Series RT - Graphs Pneumatic actuation Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice

Swing clamp cylinders Series RT - Accessories Zinc coated Steel Includes: n° 1 screw M10x20 Bracket mounting To avoid damaging the rotation system, act as shown on the drawing below; hold the bracket with a 24mm spanner when tightening the 8mm hexagonal socket screw to a maximum torque of 30 ... 40 Nm Zinc coated Steel Neoprene 85 Shore A tip Steel front and rear flange (MF1 - MF2) Plate which allows anchorage of the cylinder at a right angle to the plane. It is made of zincplated extruded steel. Overall dimensions and technical information are provided solely for informative purposes and may...

Via Cascina Barbellina, 10 24050 Lurano (BG) - Italy P. +39 035 41 92 777 [email protected]