SERIES Eco-Smart - ISO 15552 CYLINDERS WITH POSITION TRANSDUCER

Product catalog summary

Overview: The document provides technical specifications and operational details for the Eco-Smart series of ISO 15552 pneumatic cylinders with integrated position transducers. These cylinders are designed for precise position monitoring and are compliant with IP67 protection standards.

Specifications:

Bores available: Ø40, Ø50, Ø63, Ø80, Ø100.
Stroke lengths: Up to 1000 mm, in 50 mm increments.
Protection: IP67 with M12 connector for electrical connections.
Materials: Anodised aluminium barrel, chromed steel piston rod, and various seal materials depending on the version.

Construction Characteristics:

Piston rod bushings: Spheroidal bronze on steel strip with PTFE coating.
Seals: Available in PUR, NBR, and FPM depending on the version.
Pistons: Aluminium, magnetic for external sensors in Ø50 to Ø100.

Operational Characteristics:

Fluid: Filtered air, lubricated or not.
Pressure: Maximum 10 bar, minimum 1 bar.
Temperature: Varies by version, from -30°C to +80°C.

Transducer Data:

Electrical stroke: 50 to 1000 mm.
Resistance: 5 to 20 kΩ with a tolerance of ±20%.
Linearity: ±0.1% to ±0.05%.
Maximum voltage: 40 to 60 V.

Accessories and Sensors:

Compatible with ISO 15552 EcoLight series accessories.
Supports SQ, SU, and SR series sensors.

Wiring and Connection:

Uses M12A 4P connectors for power supply.
Pin configuration: Brown wire (-), Yellow wire, Blue wire (+).

Operation Instructions:

Ensure correct electrical connections and calibration of the transducer.
Do not exceed acceleration limits of 10 m/s².

Catalog excerpts

SERIES Eco-Smart ISO 15552 CYLINDERS WITH POSITION TRANSDUCER

Open the catalog to page 1

Series Eco-Smart Strokes up to 1000 mm, with 50 mm increments Wide range of accessories The cylinders of the Eco-Smart Series are pneumatic actuators according to iSO 15552 standard, equipped with a linear potentiometer integrated into the piston rod. This device enables continuous monitoring of the rod position along the entire stroke, which is detected by processing the internal resistance variation of the transducer. The pistons (from 050 to 0100) are equipped with a permanent magnet, allowing the use of external end of stroke sensors from the SQ, SU, and SR series. The dynamic seals are made...

Open the catalog to page 3

SERIES Eco-Smart - ISO 15552 CYLINDERS WITH POSITION TRANSDUCER-4

Cylinders according to standard ISO 15552Series Eco-SmartCylinder with integrated position transducer coding:13©.0.©.Q9O Table of dimensions Bore 3 | 2 Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice

Open the catalog to page 4

SERIES Eco-Smart - ISO 15552 CYLINDERS WITH POSITION TRANSDUCER-5

Series Eco-Smart Operation instructions • Make the specified electrical connections (do not use the transducer as a variable resistance). • When calibrating the transducer, be careful to set the stroke so that the output does not drop below 1% or rise above 99% of the voltage level. • The potentiometer operates based on a "magnetic drag" principle for its movement. • The allowed accelerations must not exceed 10 m/s2 to prevent decoupling of the internal element from the transducer. Transducer data All iSO 15552 ECOLiGHT series cylinder fixing devices and accessories can be used. All sensors from...

Open the catalog to page 5