The dynamic mould temperature control Benefits: • High aesthetic quality of the moulded part • No painting required • Total absence of surface irregularities or structural tensions of the moulded part • Suitable for moulds with conformal cooling channels • Applicable as a mould temperature control unit • Integral control for the heating and cooling phases of the injection cycle • Heating temperature up to 160°C • Cooling temperature down to 20°C • Eco-friendly technology Dynatemp is an innovative mould temperature control system. By using pressurized water as a medium, it performs a two-stage process. The first provides for the heating of the mould, which facilitates the inflow of the melt, resulting in uniform and complete filling even of complex geometry moulds. This avoids undesirable thermal stress of the material and greatly improves the surface quality of the moulded piece, eliminating seam lines or other imperfections. It is not necessary any paint solution and even material recycling operations are simplified. In the second, the mould is cooled to allow the injected material to solidify. This facilitates separation of the part from the sides of the mould and thus makes it

Technology: • Pressurized water Modularity: • Independent temperature control (heat&cool) for each mould half or mould area Pumps: • High pressure and flow rate pumps to achieve high thermal exchange (high Re number values) • Magnetic driven pumps Temperature control: • Remotable control panel for: - mould and fluids temperature control - commutation valves management - management of data exchange with IMM Examples of applications: Automotive (dashboard, console), Consumer Electronics and Hi-Tech, Design Products. Technical characteristics: • Circuits number: 2 indipendents for 1 mould zone •...