Series SAR & SAR-SM3W Isolated Adjustable High Voltage DC-DC ConverterPRODUCT OVERVIEW The SAR series modules are isolated DC-DC converters with 0% to 100% output voltage programmable by internal reference or external voltage. These modules have an internal reference voltage and shutdown. Protections include input over/undervoltage, over temperature and over programming. Through hole and surface mount packages are available. Every single output has a center tap for a dual output configuration. Due to a resonant design, it exhibits a very low load effect. 0-100% programmable output feature Up to 3W output power 2:1 wide input voltage range with 0.5% line regulation Protected against input over/undervoltage, over temperature and over programming Internal reference voltage feature Shutdown feature Single or dual output configuration Contact Pico for part number of available options: • Expanded operating temp: -55°C to +85°C Stabilization Bake Temperature Cycle Burn-In • Available RoHS Compliant module • Special Input Voltage, Output Voltage, Isolation Voltage or Output Power BLANK = THROUGH HOLE SM = SURFACE MOUNT www.PicoElectronics.com | Series SAR & SAR-SM

MODEL LIST High Voltage DC-DC PICO THROUGH HOLE SURFACE MOUNT Note 1: Tested at nominal input voltage and full output load. Note 2: Tested at nominal input voltage. www.PicoElectronics.com | Series SAR & SAR-SM

High Voltage DC-DC PICO SPECIFICATIONS (Nominal V|N, Full Load, TA = +25°C, 1 hour warm up unless otherwise specified) GENERAL www.PicoElectronics.com | Series SAR & SAR-SM

High Voltage DC-DC PICO TYPICAL CONNECTION CIRCUITOUTPUT VOLTAGE PROGRAMMINGRESISTOR - 5SAR & 12SAR MODELS ONLY PROG VOUT = Programmed Output Voltage VNOM = Nominal Output Voltage Rprog = Resistance in kO INTERNAL VOLTAGE REFERENCE - ALL MODELS REF Note 2: Output Voltage Programming can program the output voltage 0 to 100% Vout using 0 to 3V range. Open connection defaults to 100% Vout. Note 3: Programming Reference can be used for Output Voltage Programming (ADJ) pin. Voltage is typically 3V and current is <1mA. SHUTDOWN Note 1: Shutdown will shut down the unit when the pin is pulled below 0.4V....

Series SAR & SAR-SM High Voltage DC-DC TYPICAL CONNECTION CIRCUIT SINGLE OUTPUT OPERATION Note 4: Nominal output voltage is measured between +OUT and -OUT. For single output, COM should be disconnected. DUAL OUTPUT OPERATION +OUT LOAD Note 5: Nominal output voltage is measured between +OUT and -OUT. For dual outputs, COM will be half of the voltage between +OUT and -OUT. Both loads must be balanced. www.PicoElectronics.com | Series SAR & SAR-SM

High Voltage DC-DC PICO MECHANICAL DRAWINGSTHROUGH HOLE 1.100 [27.940] BOTTOM VIEWSURFACE MOUNT PIN 2026 REV 3 www.PicoElectronics.com | Series SAR & SAR-SM 448

Series SAR & SAR-SM High Voltage DC-DC RECOMMENDED LAND PATTERN DIMENSIONS .140 [3.556] .070 [1.778] ELEVATION VIEW PLAN VIEW UNSEALED TUBE PACKAGE TUBE PLUG TUBE PLUG POWER SUPPLY Pico warrants each product manufactured by us and sold by us or an authorized representative, to be free from defects in material and workmanship. If properly used, it will perform within its applicable specifications for a period of one year after original shipment. Pico’s obligation under this guarantee is limited to repairing or replacing our product to the original purchaser. This warranty is in lieu of all other...