Series SA & SA-SM3W Isolated Proportional High Voltage DC-DC ConverterPRODUCT OVERVIEW The SA & SA-SM series modules are isolated DC-DC converters with high efficiency, excellent load regulation, ultra-miniature case and low output ripple. It can operate in a wide temperature range without derating or heatsink. Protections include input overvoltage, and over temperature. Through hole and surface mount packages are available. Every single output has a center tap for a dual output configuration. Due to a resonant design, it exhibits a very low load effect. • At least ±10% input voltage range • Protected against input overvoltage, output short-circuit and over temperature • Shutdown feature • Single or dual output configuration Contact Pico for part number of available options: • Expanded operating temp: -55°C to +85°C Stabilization Bake Temperature Cycle Burn-In • Available RoHS Compliant module • Special Input Voltage, Output Voltage, Isolation Voltage or Output Power BLANK = THROUGH HOLE SM = SURFACE MOUNT 2025 REV 0 www.PicoElectronics.com | Series SA & SA-SM 435

Note 1: Tested at nominal input voltage and full output load. Note 2: Tested at nominal input voltage. www.PicoElectronics.com | Series SA & SA-SM

Note 1: Tested at nominal input voltage and full output load. Note 2: Tested at nominal input voltage. www.PicoElectronics.com | Series SA & SA-SM

www.PicoElectronics.com | Series SA & SA-SM

Series SA & SA-SM High Voltage DC-DC SPECIFICATIONS (Nominal VIN, Full Load, TA = +25°C, 1 hour warm up unless otherwise specified) OPTIONS AVAILABLE – CONTACT PICO FOR PART NUMBER OPTIONS AVAILABLE Referenced Standard Stabilization Bake Referenced Method 1008 Non-operating maximum storage temperature for 24 hours Temperature Cycle Referenced Method 1010 Non-operating at temperature extremes, 15 mins/temp, 10 cycles Referenced Method 1015 Max operating temperature for 160 hours Expanded Ambient Operating Temperature RoHS Compliance DATA CURVES (Nominal VIN, TA = +25°C, 1 hour warm up unless otherwise...

Series SA & SA-SM High Voltage DC-DC TYPICAL CONNECTION CIRCUIT SHUTDOWN ISOLATED SINGLE OUTPUT OPERATION Nominal output voltage is measured between +OUT and -OUT. For single output, COM should be disconnected. DUAL OUTPUT OPERATION +OUT LOAD Nominal output voltage is measured between +OUT and -OUT. For dual outputs, COM will be half of the voltage between +OUT and -OUT. Both loads must be balanced. 2025 REV 0 www.PicoElectronics.com | Series SA & SA-SM

BOTTOM VIEW LEAD DETAILS www.PicoElectronics.com | Series SA & SA-SM

Series SA & SA-SM High Voltage DC-DC RECOMMENDED LAND PATTERN DIMENSIONS - SERIES SA-SM ELEVATION VIEW PLAN VIEW TUBE PACKAGE TUBE PLUG TUBE PLUG POWER SUPPLY Pico warrants each product manufactured by us and sold by us or an authorized representative, to be free from defects in material and workmanship. If properly used, it will perform within its applicable specifications for a period of one year after original shipment. Pico’s obligation under this guarantee is limited to repairing or replacing our product to the original purchaser. This warranty is in lieu of all other warranties, express...