The MR series are regulated DC-DC converters with upgraded MIL screened / qualified components and expanded operating temperature range. The 6-sided epoxy insulated shielded case is in a low profile package - 1.900" x 1.000" x 0.300". Over 40 models are available in both single and dual isolated outputs. They can operate over the wide temperature range of -55°C to +85°C without derating, a heat sink or active cooling. • JANTX Diodes • MIL screened transformers, capacitors and resistors • Hermetically sealed transistors • Up to 3.33:1 input voltage range • Six-sided shielded case • Control feature • Trimmable output • Input/output isolation • Single and dual isolated output • No external components required • No heat sink or derating required Contact Pico for part number of available options: Stabilization Bake Temperature Cycle Burn-In • Special Input Voltage, Output Voltage, Isolation Voltage or Output Power 2025 REV 1 www.PicoElectronics.com | Series MR&nb
Open the catalog to page 1PICO MODEL LIST SINGLE OUTPUT Note 1: Tested at nominal input voltage and full output load. Note 2: Line regulation is specified at full output load, nominal to minimum input voltage (-%) and nominal to maximum input voltage (+%). Note 3: Load regulation is specified at nominal input voltage, 60% to 25% load (+%) and 60% to 100% load (-%).
Open the catalog to page 2PICO MODEL LISTDUAL OUTPUT Pico Note 1: Tested at nominal input voltage and full output load. Note 2: Line regulation is specified at full output load, nominal to minimum input voltage (-%) and nominal to maximum input voltage (+%). Note 3: Load regulation is specified at nominal input voltage, 60% to 25% load (+%) and 60% to 100% load (-%). Note 4: Dual outputs must be balanced.
Open the catalog to page 3PICO SPECIFICATIONS (Nominal VIN, Full Load, TA = +25°C, 1 hour warm up unless otherwise specified) Vacuum Impregnated Epoxy 6-Sided Epoxy Insulated Metal PROTECTION & FEATURES
Open the catalog to page 4Series MR Low Profile DC-DC TYPICAL CONNECTION CIRCUIT SINGLE OUTPUT DUAL OUTPUT Note: Use 50kΩ,1/4W trim pot between TRIM and -IN. Reduce resistance to raise output voltage to 5% maximum. Raising the output voltage beyond 5% could cause damage to the module. 2025 REV 1
Open the catalog to page 5PICO MECHANICAL DRAWINGS DUAL OUTPUT
Open the catalog to page 6Series MR Low Profile DC-DC BOX PACKAGING - BULK POWER SUPPLY CARDBOARD CARRIER POWER SUPPLY Pico warrants each product manufactured by us and sold by us or an authorized representative, to be free from defects in material and workmanship. If properly used, it will perform within its applicable specifications for a period of one year after original shipment. Pico’s obligation under this guarantee is limited to repairing or replacing our product to the original purchaser. This warranty is in lieu of all other warranties, express or implied and constitutes fulfillment of our obligations to the...
Open the catalog to page 77 Pages
12 Pages
9 Pages
12 Pages
13 Pages
9 Pages
13 Pages
9 Pages
14 Pages
13 Pages
13 Pages
14 Pages
6 Pages
8 Pages
8 Pages
8 Pages
8 Pages
6 Pages
11 Pages
13 Pages
5 Pages
8 Pages
10 Pages
12 Pages
11 Pages
10 Pages
10 Pages
10 Pages
7 Pages
6 Pages
9 Pages
13 Pages
7 Pages
7 Pages
8 Pages
9 Pages
10 Pages
8 Pages
9 Pages
8 Pages
13 Pages
7 Pages
9 Pages
9 Pages
6 Pages
8 Pages
8 Pages
14 Pages
8 Pages
10 Pages
6 Pages
7 Pages
8 Pages
8 Pages
7 Pages
9 Pages
10 Pages
12 Pages
7 Pages
13 Pages
9 Pages
10 Pages
13 Pages
13 Pages
13 Pages
12 Pages
12 Pages
8 Pages