The HVP series modules are 0% to 100% output voltage programmable by internal reference or external voltage plus additional 10% fine-tune calibration. These modules have a voltage monitor and shutdown features. Protections include input overvoltage, output short-circuit, output overload, and over temperature. Precise line & load regulation with low ripple down to 0.007% peak to peak. The 2.55" x 1.3" x 0.5" low profile 6-sided shielded metal case size will mitigate EMI noise and inteference. • 0-100% programmable output feature • 11-16 VDC input voltage range • 100 to 6kV nominal output voltage models • Compact 2.55" x 1.3" x 0.5" 6-sided metal case • Protected against input overvoltage, output short-circuit, output overload and over temperature • 3 voltage programming methods • Down to 0.007% peak to peak ripple • Shutdown feature • Output voltage monitor feature • 10% fine-tune calibration adjustment screw Contact Pico for part number of available options: • Expanded operating temp: -55°C to +85°C Stabilization Bake Temperature Cycle Burn-In • Special Input Voltage, Output Voltage, Isolation Voltage or Output Power P = POSITIVE OUTPUT N = NEGATIVE OUTPUT

Series HVP High Voltage DC-DCSPECIFICATIONS (Nominal VIN, Full Load, TA = +25°C, 1 hour warm up unless otherwise specified)INPUT Parameter Operating Frequency

Series HVP High Voltage DC-DCSPECIFICATIONS (Nominal VIN, Full Load, TA = +25°C, 1 hour warm up unless otherwise specified)PROTECTIONS & FEATURES Overtemperature OPTIONS AVAILABLE - CONTACT PICO FOR PART NUMBER Parameter

Series HVP High Voltage DC-DC TYPICAL CONNECTION CIRCUIT OUTPUT VOLTAGE PROGRAMMING EXTERNAL VOLTAGE & SHUTDOWN LOAD PROG INTERNAL VOLTAGE REFERENCE & RESISTIVE DIVIDER Note 1: Output Voltage Programming can program the output voltage from 5 to 100% Vout using 0.25 to 5V range. Linearity is 1% max for 10 to 100% Vout. Linearity will be >1% from 0 to 10% Vout. Unit requires Output Voltage Programming to be >0.25V to turn on and operate normally. Note 2: Programming Reference can be used for Output Voltage Programming pin. Voltage is typically 5V and current is <1mA. Note 4: COM IN, COM OUT & case...

Series HVP High Voltage DC-DC MECHANICAL DRAWINGS Ø .150 [Ø 3.810] EPOXY INSULATION CIRCLE X 4 2.100 [53.340] Ø .400 [Ø 10.160] EPOXY INSULATION CIRCLE BOTTOM VIEW NOTES a. ALL DIMENSIONS ARE IN INCHES, [ ] = MM b. METAL CASE CONNECTED TO PIN NUMBERS #5 & #6 c. PIN # 7 (OUT) PCB TRACE SHOULD NOT BE ON THE SAME LAYER AS THE NON-INSULATED METAL CASE DUE TO POTENTIAL SHORT. ALTERNATIVELY, STANDOFFS CAN BE USED TO PREVENT ANY SHORTS BETWEEN PIN #7 (OUT) PCB TRACE AND THE NON-INSULATED METAL CASE. 2025 REV 1

Series HVP High Voltage DC-DC MECHANICAL DRAWINGS ADJUSTMENT SCREW SLEEVE FEATURED ON MODELS 1000VDC OUTPUT ONLY CARDBOARD CARRIER POWER SUPPLY CARDBOARD CARRIER POWER SUPPLY Pico warrants each product manufactured by us and sold by us or an authorized representative, to be free from defects in material and workmanship. If properly used, it will perform within its applicable specifications for a period of one year after original shipment. Pico’s obligation under this guarantee is limited to repairing or replacing our product to the original purchaser. This warranty is in lieu of all other warranties,...