*mydirectindustry

MLL-N-457

Product catalog summary

Product Overview: The document provides technical specifications for the 457nm DPSS Laser by PhotonTec Berlin GmbH. This laser is characterized by its all-solid-state design, ultra-compact size, and cost-effectiveness, making it easy to use in various applications.

Key Features:

All solid-state laser construction.
Ultra-compact and low-cost design.
Easy-to-use with less than 3% amplitude noise (rms, 1Hz-20MHz).

Applications: The laser is suitable for use in biomedicine, biochemistry, Raman spectroscopy, laser printing, display technologies, and fluorescence sensing.

Specifications:

Operating Temperature: 10 - 35°C.
Warm-up Time: Less than 15 minutes.
Beam Divergence: Less than 1.5 mrad.
Beam Diameter at Aperture: Approximately 3.0 mm.
Power Stability: Less than 3%, 5%, or 10% (rms, over 4 hours at 25°C).
Operating Mode: Continuous Wave.
Transverse Mode: Near TEM01.
Output Power Options: 1000, 1500, 2000 mW.
Wavelength: 457 ± 1 nm.
Polarisation Ratio: Greater than 100:1.
Expected Lifetime: 10,000 hours.

Physical Dimensions:

Laser Head: 240 x 99 x 94 mm.
Power Supply Unit: 238mm (L) × 146mm(W) × 102mm(H), 2.3 kg.
Overall Dimensions: 268mm (L) × 145mm(W) × 106mm(H), 2.6 kg.

Additional Notes:

Improper use or operation above specified conditions may reduce the laser's lifetime.
A non-condensing environment is required for storage and operation below the ambient dew point.
Specifications are subject to change without notice.

Catalog excerpts

The Photonics Solution Company 457nm DPSS Laser Features - All solid state laser - Ultra compact - Low cost - Easy-to-use - Biomedicine and biochemistry - Raman spectrum - Laser printing and display - Fluorescence sensor Operating Mode Continuous Wave Transverse Mode Beam Divergence (full Angle, mrad) Beam Diameter at the Aperture (mm) Power Stability (rms, 4 hours @25°C) Polarisation Ratio Warm-up Time (minutes) Expected Lifetime (hours) Laser Head Power Supply Unit (90-260VAC) Notes: 1. Reduced lifetime if improperly used or used above operating conditions. 2. A non-condensing environment is required for storage and operation below the ambient dew point. 3. Product specifications are subject to change without notice. PhotonTec Berlin GmbH Max-Planck-Str. 3 D- 12489 Berlin Germany

Open the catalog to page 1

MLL-N-457

MLL-N-457

Catalog excerpts

All PhotonTec Berlin GmbH catalogs and technical brochures