General Specifications:
The LD1000C actuator has a maximum force of 10,000N and a speed adjustment capability of up to 156mm/s. The stroke length ranges from a minimum of 15mm to a maximum of 1000mm. Installation dimensions vary based on stroke length, with specific measurements provided for strokes less than and greater than 400mm. It is certified under NRTL standards, specifically UL 61800-5-1:2012/R:2021-02 and CSA C22.2 No. 274:2017. The duty cycle is 30%, and it supports position feedback and synchronous operation. The supply voltage options are 12VDC and 24VDC, and it includes an integrated limit switch and end position signal. The protection class is IP69K (static), and it is self-locking up to the nominal load.

Materials and Components:
The rod end and housing end are made of stainless steel with a hole diameter of 12.1mm. The lift tube is also stainless steel, while the housing is made from die-cast aluminum with an anodized aluminum profile, colored similarly to RAL 9005 black. The stroke pipe is stainless steel, and the connection is via an M12 connector with cable lengths of 3m, 5m, or 10m. Options for suspensions and special strokes are available.

Control and Feedback:
The actuator features programmable start/stop ramps, speed control, and configurable speed. It can be operated via a hand switch or PLC. Position feedback options include end position feedback (both potential bound and potential-free), an absolute position measuring system, and analog position feedback. Communication interfaces and internal protection mechanisms such as power shutdown and temperature monitoring are included.

Technical Drawing and Measurements:
The document includes a technical drawing with detailed measurements for various stroke lengths, providing specific dimensions for installation and operation.

Performance Data:
The performance data section is referenced but not detailed in the provided text.