GAS SAFETY
1 /5Pages

GAS SAFETY

GAS SAFETY
1 /5Pages

Catalog excerpts

GAS SAFETY-1

GAS SAFETY PRODUCTS FOR CIVIL INSTALLATION GAS DETECTION SERIES ZEFIRO PRODUCTS FOR INDUSTRIAL INSTALLATION GAS DETECTION CONTROL UNITS 6-9 DIN modular units GAS DETECTION CONTROL UNITS IN SWITCHBOARDS GAS SENSORS IP44 SENSORS IP55 SENSORS IP55 SENSORS SOLENOID VALVES Class “A” type-approved NC valves NO Normally Open valves NC Normally Closed valves Special voltages upon demand

 Open the catalog to page 1
GAS SAFETY-2

GAS DETECTION WALL-MOUNTING KITS CEI 216-8 (semi-recessed), EN 50194 (explosive gases), EN 50291 (toxic gases) EN 50270

 Open the catalog to page 2
GAS SAFETY-3

GAS SAFETY WALL-MOUNTED AND/OR SEMI-RECESSED GAS DETECTION ZEFIRO CODE Wall-mounted and/or Semi-recessed natural gas (CH4) detector with BUS output series “ZEFIRO” Power supply 230V a.c. 50-60Hz 1 potential-free changeover contact output: 8(2)A/250Va.c. Microprocessor with fume selection program to prevent false alarms Microprocessor with timer to signal product service every 5 years Remote sensor recognition (BUS system) Digital BUS output for signaller control (max 15) Interconnection length max 800m (2x1.5 sq.mm) Alarm memory Fault indicator LED Gas concentration LED on 3 signalling levels...

 Open the catalog to page 3
GAS SAFETY-4

GAS SAFETY WALL-MOUNTED AND/OR SEMI-RECESSED GAS DETECTION ZEFIRO CODE Wall-mounted and/or Semi-recessed natural gas (CH4) detector with BUS output series “ZEFIRO” Power supply 230V a.c. 50-60Hz 1 potential-free changeover contact output: 8(2)A/250Va.c. Signalling buzzer 85dB at 1m ON indicator LED Fault indicator LED Gas presence indicator LED Intervention level 5000 ppm 10% LIE Wall-mounted IP 42 Dimensions (LxWxH) 120 x 40 x 82 Semi-recessed installation with accessory IP 40 Dimensions (LxWxH) 120 x 27.5 x 82 Wall-mounted and/or Semi-recessed LPG gas detector with BUS output series “ZEFIRO”...

 Open the catalog to page 4
GAS SAFETY-5

GAS SAFETY WALL-MOUNTED GAS DETECTION CODE Wall-mounted carbon monoxide (CO) and natural gas (CH4) detector The detector can detect two gases: natural gas (CH4) and carbon monoxide (CO) Intervention sensitivity: - natural gas at 10% of the lower explosion limit - carbon monoxide, when the maximum allowed 300ppm CO concentration is exceeded, or rather in case low but damaging concentrations 30ppm for 2 hours persist for long periods in the premises. Power supply 230V a.c. 50-60Hz 2 potential-free changeover contacts output: 5(2)A/250Va.c. Natural gas catalytic sensor Natural gas intervention level...

 Open the catalog to page 5
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.