ANAEROBIC GASKET ANAEROBIC FORMED-IN-PLACE GASKETS, LIKE PERMATEX® ANAEROBIC GASKET MAKER, CURE IN THE ABSENCE OF AIR AND IN THE PRESENCE OF ACTIVE METALS. Permatex Anaerobic Benefits: • Controlled tolerances: allows metal-to-metal contact. Fills • Fills potential leak paths: recommended for finely machined surfaces. One • One tube for all shapes and sizes: reduces need for costly gasket inventory. • 100% seal: eliminates flange face corrosion. • Single part: easy and clean to apply. ANAEROBIC GASKET MAKER #51813 • OEM specified. Non-corrosive gasketing material designed primarily for use on aluminum, iron, and steel flanged mating surfaces. • Ideal when a conventional gasket is unavailable (not for use with conventional gaskets). • Fills gaps up to .015” and cures to a solvent-resistant seal that will not tear or decay during service. • Parts disassemble easily even after extended service. • Old gasket material can be removed in minutes with the Permatex Safer Scraper. Hartford Square North, 10 Columbus Boulevard Hartford, Connecticut 06106 Permatex and Design are TMs of Illinois Tool Works Inc. Copyright © 2016 Permatex, an Illinois Tool Works c

Anaerobic Gasketing Technology TRADITIONAL METHOD TRADITIONAL METHOD PERMATEX® SOLUTION PRE-FORMED MATERIALS • Relaxation • Re-torquing • Constant seal/no re-torquing • Total seal • Automation possible • Manual application • Extra machining operation • Large inventory • Automation possible • Standard parts used • No parts to handle • Low inventory • Often solvent-based • Can cause clogging • Re-torquing • Messy • Solvent-free • No relaxation • Excess material can be wiped away • Accurate and precise application • Time consuming • Operator skill • Inconsistent performance • Little preparation...