The pressure injection pump PGP 30/40 is an pneumatic driven 2- component gearpump, suitable for the work under mining and civil engineering conditions. It consists of a powerfull 8kW pneumatic drive and two mining approved high capacity gearpumps. With its high constant flowrate of 40 l/min at a pressure up to 40 bar, it is the perfect pump for all injections works where you must be able to pumpe a lot material in a short time frame. Of course this pump can be uses with all common Polyurethan injection resins. With additional gearpumps, that can be purchased optional, it is also possible to use this pump with injection resins which need a mixing ratio od 2:1 or 4:1. For safety reasons this machine is equipped with overpressure valves at both pressure outlets, and a mining approved pressure switch. Application: The PERFORATOR PGP 30/40 is a powerfull gearpump for the injection of 2- component injection Materials, mainly used in the mining and civil engineering industry. It is meant for the use with common 2- component Polyurethan injection Materials with a mix ratio of 1:1. Due to the high flowrate generated by this pump it is predestined for all jobs where you have to pump much material in a short period of time. Technical Data: Air drive pressure Max. operating pressure Max. pneumatic drive power Suction connection Chamber volume of each gearpump Pressure outlet Polyurethan Silicate resin ca. 40 l/min at max. 40 bar / 580 psi Max. flow rate Dimensions Height Width Length Within the specified technical features and performance data, engineering and design of our products are subject to change. To all products and services our general terms and conditions, incl. Product liability, apply exclusively. (Perforator, Technical Data Sheet PGP 30/40, Rev. 01/ 2012)