The pressure injection pump HIP 5.5/150 is a hydraulic driven, single acting piston pump, operating acc. to the pressure intensification principle. The pump consists of a hydraulic actuated drive part and a high pressure part, which are connected by a plunger. Two parallel fitted high-pressure pistons at the end of the plunger are connected via yoke. Thus, the drive and high pressure parts are isolated, which prevents that pump medium could get into the hydraulic drive part in case of leakages of the high-pressure sealing. The pump is equipped with an overflow protection at both pressure outlets. The plunger is made of high-tensile stainless steel and is distinguished by long service life. The valve seats are of tempered steel and the gaskets are of wear-resistant PTFE. Application: The HIP 5.5/150 is a compact injection pump with small dimensions and low weight, but with a high flow rate. It is mainly used as pipeline pump to supply injection fluids on Polyurethane basis and in a mixing ratio of 1:1 from gate road to longwall face. Technical Data: Max. hydraulic drive pressure Max. operating pressure Connections Hydraulic connection inlet Pressure ratio Hydraulic connection outlet Stroke volume per double stroke Suction connection Pressure outlet Polyurethan Weight ca. 112 kg Silicate resin Max. flow rate ca. 11 l/min on free outlet For information of flow rates at the different pressure stages please refer to the performance graph. Hydraulic piston diameter 60 mm High-pressure piston diameter 30 mm Dimensions Height 500 mm Width 500 mm Length 1200 mm Within the specified technical features and performance data, engineering and design of our products are subject to change. To all products and services our general terms and conditions, incl. Product liability, apply exclusively. (Perforator, Technical Data Sheet HIP 5.5/150, Rev. 01/ 2012)