Group: ESP / Novarc
Catalog excerpts
PNEUMATIC TESTER
Open the catalog to page 1Magnet Option For mounting on metal walls Before each use, each insulating glove should be visually inspected and checked by an air pressure test (according to the recommendations of standards EN 60903 and IEC 60903)*. Visual and meticulous inspection of the entire surface of the glove is necessary to detect any perforations or other defects such as : • Holes • Cuts • Chemical stains • Burn marks or • Material alteration Particular attention should be placed on the palm, �ngers and between the �ngers. This veri�cation must be done before each use* • in the event of a fault, do not use the...
Open the catalog to page 2veral models available! • 110 mm for TOUCH-e gloves • 130 mm for CEI type gloves m for ASTM type gloves (removable ring) • Achieved by successive presses on the button superior. • The two side lugs provide good support to make in�ation easier • Simply press the button shown below for controlled de�ation Storage position • The device can be compressed as shown below w
Open the catalog to page 3• ABS body • NBR bellows • Supplied with fabric bag Insulating gloves are classi�ed in CATEGORY III of Personal Protective Equipment because they protect against the most severe risks. Simple Design to protect against super�cial injuries Intermediate Design to protect against more serious injury Complex Design to protect against serious or fatal injury Models & references Glove type IEC Glove type ASTM Ref: EOSM9030 LEOS-EN • Text and illustrations not contractually binding. The information in this document may be modified at any time with
Open the catalog to page 4All PENTA catalogs and technical brochures
-
Live working
172 Pages
-
NEVERS BT
2 Pages
-
Lockout Padlocks
12 Pages
-
HTAG
3 Pages
-
Electric traction
68 Pages
-
MTAG
4 Pages
-
TAG780
4 Pages
-
Rescue Kit
6 Pages
-
Insulated tools
24 Pages
-
Electric mobility
52 Pages
-
DR706
3 Pages
-
Touch-e
8 Pages
-
Picoup 250
4 Pages
-
Picoup 400
4 Pages
-
Our products
622 Pages