TD 415
6Pages

Catalog excerpts

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS PEM® TY-D® self-clinching tie-mounts and hooks provide secure attachment points for mounting wires to electronic chassis or enclosures. All TY-D hardware installs quickly and permanently without screws and eliminates the use of adhesives that typically fail over time and temperature cycling. TY-D hardware can be a great improvement over traditional mounting methods. They can be placed with assurance at designed locations and angles to remain secure for the life of the assembly; they will not protrude on the reverse side and will not affect the...

Open the catalog to page 2

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS TYPE TD™ CABLE TIE-MOUNTS Hole In Sheet Clinching profile may vary. Min. Hole Min. Hole Edge To Edge To Sheet Edge Sheet Edge K M Length Code Sheet Thickness Hole Size In Sheet +.002 -.001 Min. Hole Min. Hole Edge To Edge To Sheet Edge Sheet Edge K M Length Code Sheet Thickness Hole Size In Sheet +0.05 –0.03 (1) Reference to typical load rating (in pounds) for appropriate size nylon cable tie. PART NUMBER DESIGNATION Length Code Profile Shown Actual Size.

Open the catalog to page 3

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS TYPE TDO™ CABLE TIE HOOKS Hole In Sheet E Clinching profile may vary. All dimensions are in inches. Length Code Sheet Thickness Hole Size In Sheet +.002 -.001 Min. Hole Min. Hole Edge To Edge To Sheet Edge Sheet Edge K M Hole Size In Sheet +0.05 –0.03 Min. Hole Min. Hole Edge To Edge To J Nom. Sheet Edge Sheet Edge K M Length Code Sheet Thickness (1) Reference to typical load rating (in pounds) for appropriate size nylon cable tie. PART NUMBER DESIGNATION Length Code Profile Shown Actual Size. Type TDO open end orientation mark. PennEngin

Open the catalog to page 4

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS AND HOOKS MATERIAL AND FINISH SPECIFICATIONS MATERIAL: Sintered Steel FINISH: ZI- Zinc plated, 5µm, colorless FOR USE IN SHEET HARDNESS: HRB 60 / HB 107 or less (1) See PEM Technical Support section of our web site for related plating standards and specifications. (2) HRB - Hardness Rockwell “B” Scale. HB - Hardness Brinell. INSTALLATION 1. Punch a properly sized rectangular mounting hole in the sheet. Do not perform any secondary operations such as deburring. 2. Place the fastener through the mounting hole (preferably the punch side) and into the...

Open the catalog to page 5

(1) Published installation forces are for general reference. Actual set-up and confirmation of complete installation should be made by observing proper seating of fastener as described in the installation steps. Other performance values reported are averages when all proper installation parameters and procedures are followed. Variations in mounting hole size, sheet material, and installation procedure may affect performance. Performance testing this product in your application is recommended. We will be happy to provide technical assistance and/or samples for this purpose. Pull Thru- Side...

Open the catalog to page 6